ECS L7S7A Manual page 31

•
Two IDE connectors which support four IDE channels and
a floppy disk drive interface
The L7S7A supports Ultra DMA bus mastering with transfer
rates of 33/66/100 MB/sec.
•
Integrated Serial ATA Link and PHY logic
Sil3112A Serial
•
Compliant with Serial ATA 1.0 specifications
ATA (optional)
•
Supports two independent Serial ATA channel
•
Supports Serial ATA Generation 1 transfer rate of
1.5Gb/s
•
Supports Spread Spectrum in receiver
•
Single PLL architecture, 1 PLL for both ports
Onboard LAN The Realtek RTL8100B LAN chip is incorporated in the chipset
(optional) providing the mainboard with 10/100Mbps fast Ethernet con-
troller and integrated Ethernet PCI LAN capabilities.
RTL8201BL is a Fast Ethernet Phyceiver with an MII (Media
Independent Interface)/SNI (Serial Network Interface). It can
be used as a Network Interface Adapter, MAU, CNR, ACR,
Ethernet Hub, and Ethernet Switch.
•
Fully support provisions of IEEE1394-1995 for High- Per-
IEEE 1394A Con-
formance Serial Bus and the P1394a draft 2.0 standard
troller Interface
•
Provides one compliant cable port at 100Mbits/s,
(optional)
200Mbits/s, and 400Mbits/s
•
Supports arbitrated short bus reset to improve utilization
of the bus
•
Data interface to link-layer controller provided through
2/4/8 parallel lines at 50Mbits/s
•
Support power-down feature to conserve energy in bat-
tery powered applications
Integrated I/O The mainboard has a full set of I/O ports and connectors:
•
Two PS/2 ports for mouse and keyboard
•
Two serial port
•
One parallel port
•
One MIDI/game port
•
Two USB ports
•
One LAN port
•
Audio jacks for microphone, line-in and line-out
BIOS This mainboard uses AMI BIOS that enables users to config-
Firmware ure many system features including the following:
•
Power management
•
Wake-up alarms
•
CPU parameters
•
CPU and memory timing
The firmware can also be used to set parameters for different
processor clock speeds.
4