Toshiba PORTÉGÉ M700 Maintenance Manual page 260

4 Replacement Procedures
Installing the keyboard
The following describes the procedure for installing the keyboard. (See Figure 4-15 to 4-18.)
1. Place the keyboard face down on the palm rest.
2. Connect the keyboard cable to the connector CN3230 on the system board.
CAUTION: Extra portion of the keyboard cable must be put under the palm rest.
3. Install the keyboard cover and secure it with the following screw. (Insert the guide
of the keyboard cover first)
• M2.5×3.0C
4. Turn the keyboard face up and insert the four guides of the keyboard into the four
slits. Set the keyboard while pushing the latch. Make sure the guide of the keyboard is
under the latch.
5. Secure the keyboard with the following screws.
• M2.0×3.0C
6. Install the keyboard holder while engaging the latches.
4-32 [CONFIDENTIAL]
S-THIN HEAD screw
S-THIN HEAD screw
PORTÉGÉ M700 Maintenance Manual (960-661)
4.10 Keyboard
×1
×2