Toshiba PORTÉGÉ M700 Maintenance Manual page 251

4.7 Slim select bay module
Installing the slim select bay module
The following describes the procedure for installing the slim select bay module. (See Figure
4-10 and 4-11.)
1. Install the ODD side assembly to the optical drive assembly and secure it with the
following screws.
• M2.0×6.0C
• M2.0×22.0C
2. Install the connector base to the optical drive assembly and secure it with the
following screw.
• M2.0×3.0C
3. Install the connector cover and connector to the optical drive assembly and secure
them with the following screws.
• M2.0×6.0C
4. Insert the slim select bay module into the slot to connect it to the connector on the
system board. Press to ensure a firm connection.
5. Remove the following screw from the screw hole. Then secure the latch with the
removed screw. (The slim select bay is locked.)
• M2.5×4.0B
PORTÉGÉ M700 Maintenance Manual (960-661)
BIND screw
BIND screw
S-THIN HEAD screw
BIND screw
FLAT HEAD screw
4 Replacement Procedures
×1
×1
×1
×2
×1
[CONFIDENTIAL] 4-23