Mowing Advice - Qualcast M2E1232M Instruction Manual

Operating Instructions & Tips

Mowing Advice

We recommend that you mow in overlapping lines. Only mow with a sharp blade so that the blades of
grass do not fray. This can cause grass to turn yellow. To achieve a good cut, guide the lawn mower in lines
that are as straight as possible. These lines should always overlap by a few centimeters so that you do not
leave any uncut strips.
How often you need to mow your lawn depends on how fast the grass is growing. During the main growth
period mow more frequently. If the grass is longer than usual, cut it in 2 or more stages. This will cause less
stress to both the mower and the grass. Never cut the grass by more than half its height.
Keep the under side of the mower casing clean and remove all grass deposits from it. Deposits make it
more difficult to start the mower and also adversely affect the mowing quality and the grass collection.
Switch off the motor before you carry out any inspections of the blade. Remember that the blade will
continue to turn for a few seconds after the motor has been switched off. Never attempt to stop the blade.
Check regularly that the blade is correctly secured, in good condition and sharp. If not, sharpen or replace
the blade.
If the moving blade strikes an object, stop the mower and wait until the blade has come to a complete
standstill. Then check the condition of the blade and the blade mounting. If they are damaged, they must
be replaced.
Place the mains lead in loops on the ground near the wall socket. Mow away from the socket and cable
and ensure that the mains lead is always on the section of lawn that you have already mowed so that you
do not run over the mains lead with the mower.
If you you see mown grass on the lawn whilst you are mowing it means the grass collector is full and
needs to be emptied immediately.
IMPORTANT! Before you remove the grass collector, switch off the motor and wait until the blade
reaches a complete standstill.
To remove the grass collector, raise the deflector guard with one hand and remove the grass collector
holding its handle with your other hand.To maintain safety, the deflector guard will close when you
remove the grass collector to seal the rear discharge opening. If any grass drops onto the ground you need
push the mower away from the area to make it easier to re-start the motor.
Do not remove grass cuttings in the mower casing or on the cutter by hand or with your feet. Instead
use suitable tools such as a brush or broom. To ensure efficient grass collection the grass collector should
be cleaned after use. This will ensure the air is able to flow freely through it for best grass collection
performance.
Only fit the grass collector when the motor is switched off and the blade is not moving. Raise the deflector
guard with one hand and, holding the grass collector by its handle in your other hand, position it squarely
onto its support. Ensure it fits snug against the body of the mower before starting.
18
Customer Helpline 08456 400 800