Advertisement
Advertisement
Table of Contents
Related Manuals for Qualcast Cobra 32
Summary of Contents for Qualcast Cobra 32
- Page 1 COBRA 32 OPERATING INSTRUCTIONS...
-
Page 2: Safety Rules
Replace worn or damaged blade and bolts in sets to preserve balance. Mow only in daylight or in good artificial light. Atco-Qualcast Ltd, Suffolk Works, Stowmarket, Suffolk, IP14 1EY, England Printed in England Safety Rules Avoid operating the lawnmower in wet grass, where feasible. -
Page 3: Electrical Safety
If any components are missing please call the Consumer Care Hotline on (01449) 742130 for assistance. We also have a wide network of Qualcast Approved Service Agents who you can contact for service and advice both within and outside the period of the guarantee. -
Page 4: Starting And Stopping
Height of Cut Adjustment Stop, release switch lever before adjusting height. Your machine has seven settings which give the following approximate height of cuts; 1 = 18 mm 2 = 22 mm 4 = 32 mm 5 = 40 mm Remove the grassbox to aid adjustment (see ‘Grassbox’). - Page 5 Step Step...
-
Page 7: Fault Finding
The following table gives checks and actions that you can perform if your machine does not operate correctly. If these do not identify/remedy the problem contact your Qualcast approved service agent. Warning - switch off, remove plug from mains before investigating fault. - Page 8 Should you require replacement parts, always insist on genuine Qualcast replacement parts. Any damage caused to the product through the fitting of parts not made by Qualcast is not covered by the guarantee. Your statutory rights are not affected by this guarantee.
Need help?
Do you have a question about the Cobra 32 and is the answer not in the manual?
Questions and answers
The red button for lowering or raising the cutting level seems not to be working. Any solution?
To fix the red button for lowering or raising the cutting level on a Qualcast Cobra 32, follow these steps:
1. Remove the grassbox to access the height adjustment mechanism.
2. Press and hold the height of cut button.
3. Lift up or push down the machine until the desired height (1 to 7) is shown.
4. Release the button to lock the height; you should hear a click when it locks.
If the button is not working (stuck or unresponsive), inspect for obvious defects such as damage or obstruction. Check if any parts are loose or worn. If damaged, the button or mechanism may need replacement. Disconnect power before inspecting or repairing.
This answer is automatically generated