Step 3 - Mowing - Qualcast XSS41D Assembly Manual

Operating the Lawnmower
Failure to start

Step 3 - Mowing

If the engine won't start after you have operated the starter several times, the engine may be
flooded with excess fuel.
Use following procedure to clear and start a flooded engine:
A. Release the stop/start bar.
B. Remove the spark plug, dry it, and then reinstall it .
Install the spark plug carefully by hand, to avoid cross-threading. After the plug is seated, tighten
1/8 to 1/4 turn with socket spanner of spark plug to compress the washer.
C. Pull the stop/start bar towards the upper handle.
D. Operate the starter as described above.
Step 3 - Mowing
WARNING!
- Always observe the strictest safety procedures when using the lawnmower.
Mowing with grass bag
Start the engine and allow it run .See "Step-2 Starting the engine"
Keep a firm grip on the upper handle with stop/start bar and walk bar closed and push the
lawnmower walking along it, never run with the mower, be very careful when mowing uneven or
rough ground. Mow across slopes, never up and down. Be careful when changing the direction of
the mower on a slope. Do not use the mower on a steep slope of more than 15°.
NOTE!
- The best result will be achieved if the grass is dry. Wet grass will tend to clog the blade and the
grass collection system. Grass grows at different rates at different time of the year.
- Never use the lowest cutting height for the first cut of the season or in drought conditions. Only
about one thirds of the grass height should be cut.
- If the lawnmower will not collect the cuttings efficiently, the grass discharge chute may be
blocked. The grass bag may be full, or the underside of the mower deck may be clogged.
Customer Helpline 01904 727500
www.gardenservicecentre.co.uk
11