Step 3 - Mowing - Qualcast XYM188-2BSJE Assembly Manual

Operating the Lawnmower
Step 2 - Starting the Engine (continued)
2a
2a Press the primer bulb (A) 3-5 times.
When starting a cold engine, press down the primer fully 3~5 times.
When starting a warm engine, the primer does not need to be used. If the engine stops due to a
lack of petrol, refill and press down the primer 3~5 times.
2b Starting Throttle Position
Move the throttle lever to the RABBIT position
2c
2c Start/Stop Bar Activation
Pull the Start/Stop bar towards you.
2d Pull cord handle
With right hand, slowly but firmly pull the starter handle and rope from the pull cord guide until
you feel resistance, then pull briskly. If the engine fails to start after three pulls, repeat the start
process. When the engine starts, return the starter rope to the pull cord guide gently.
Customer Helpline 0845 034 2279
10
www.gardenservicecentre.co.uk
A
.
2d
Operating the Lawnmower
Step 2 - Starting the Engine (continued)
2e Running Throttle Position
Once the engine is running, ensure the throttle lever is in the RABBIT position
NOTE ! Clearing a flooded engine:
If the engine won't start after you have operated the starter several times, the engine may be
flood with excess fuel.
Use following procedure to clear and start a flooded engine:
A. Release the stop/start bar.
B. Remove the spark plug, dry it, and then reinstall it .
NOTE! Install the spark plug carefully by hand, to avoid cross-threading. After the plug is seated,
tighten 1/8to 1/4 turn with socket spanner of spark plug to compress the washer.
C. Pull the stop/start bar toward the upper handle. Move the throttle lever to RABBIT position.
D. Operate the starter as described above.

Step 3 - Mowing

1. Mowing with grass bag (Be sure to remove the side discharge chute and take out the
mulching plug)
WARNING! Always observe the strictest safety procedures when using the lawnmower.
Carefully read the safety instructions of this manual before using the lawnmower.
Start the engine and allow it run .See "Step-2 Starting the engine"
Before mowing, ensure the throttle lever is in the RABBIT position
To stop the engine, release the stop / start bar.
Keep a firm grip on the upper handle with stop/start bar and walk bar closed and walk along
with it self-propelling, never run with the mower, be very careful when mowing uneven or rough
ground. Mow across slopes, never up and down. Be careful when changing the direction of the
mower on a slope. Do not use the mower on a steep slope of more than 15°.
The best result will be achieved if the grass is dry. Wet grass will tend to clog the blade and the
grass collection system. Grass grows at different rates at different time of the year.
Never use the lowest cutting height for the first cut of the season or in drought conditions. Only
about one thirds of the grass height should be cut.
If the lawnmower will not collect the cuttings efficiently, the grass discharge chute may be
blocked. The grass bag may be full, or the underside of the mower deck may be clogged.
Customer Helpline 0845 034 2279
www.gardenservicecentre.co.uk
.
.
11