Safety Warning Warning! Read these instructions carefully, familiarise yourself with the controls and the correct usage of the machine. Please keep the instructions safe for later use. Explanation of symbols on the machine Beware of hazard, Read instruction manual. Wear eye and ear protection. Do not use the machine in the rain or leave it outdoors when it is raining.
Page 5
Warning. Beware of electric shocks. Keep the mains supply cord away from the cutting blade. Wait until all moving parts have stopped completely before touching them. The blade may continue to rotate after the machine is switched off, a rotating blade can cause injury. Noise level specification L in dB.
We accept no liability for damage or accidents which arise due to non-compliance with these instructions. General safety instructions Note: Only supply power to the equipment through circuit protected by an RCD with a maximum trip current of 30 mA. ►...
Page 7
► Always wear strong, anti-slip footwear and long trousers when using the mower. Never mow in bare feet or in open-toed sandals. ► Always use the lawn mower with the grass collector attached or with the safety flap closed if you are not using the grass collector. ►...
Page 8
► If the lawn mower begins to vibrate abnormally, switch it off immediately , disconnect the plug immediately and check it carefully. ► Ensure that all the nuts, bolts and screws are tight and that the mower is in a safe condition for use. ►...
Page 9
► Use only plugs or connectors approved for outdoor usage. ► Ensure that you do not push the mower over areas that might damage or snare the power cable ► Do not switch the mower on and off frequently over a short period of time, and in particular do not play with the ON/OFF switch.
Technical data Voltage: 220-240 V ~ 50 Hz Power input: 1000W watts Motor speed: 3350min Cutting width: 32cm Cutting height adjustment: 20, 40, 60 mm Volume of grass collector: 33 liters LpA sound pressure level: 73.5dB(A) LWA sound power level: 96 dB(A) Vibration at the handlebars ahv: <...
Page 12
Usage Attention: Do not operate the mower unless the deflector guard and grass collector are fully installed. Risk of injury! Fitting / removing the grass collector - Lift the deflector guard (7) - Place the grass collector on the mounting bracket at the back of the lawn mower.
Before you begin to mow, check to ensure that the blade is not blunt and that none of the fasteners are damaged. To prevent any imbalance, replace blunt and/or damaged blades. To carry out this check, first switch off the motor and pull out the power plug.
Operation Before you connect the equipment to the mains supply make sure that the data on the rating plate corresponds to your mains supply. Important! Always ensure the on/off switch is working correctly. Do not use if you suspect a fault. Before you perform any repair or maintenance work on the machine, ensure that the blade is not rotating and that the power supply is disconnected.
Page 15
grass deposits from it. Deposits make it more difficult to start the mower and also adversely affect the mowing quality and the grass collection. Switch off the motor before you carry out any inspections of the blade. Remember that the blade will continue to turn for a few seconds after the motor has been switched off.
Cleaning & maintenance Always disconnect the mains power plug before starting any cleaning work. Cleaning ► Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure.
Page 17
Maintenance and storage ► There are no parts inside the equipment which require additional maintenance. ► keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition at all times. ► check the grass collector frequently for wear or deterioration; ►...
Trouble Shooting Problem Possible Cause Corrective Action Check the switch, socket, cable, wire and No power at mains have any repairs socket carried out by an electrician Defective on/off switch Repair by a qualified Worn carbon brushes Mower does not start technician required Defective motor Set at a higher cut...
Page 19
Argos Cat No. : 7304905 Supplier Model No.: M2E1032M Product Description: Lawn mower Complies with the requirement of the following directives: 2006/42/EC ----Machinery Directive 2006/95/EC ----Low Voltage Directive 2004/108/EC ----EMC Directive Test Lab Name: TÜV Product Service Ltd. Jiangsu Address: 10 Huaxia Road(M), Dongting, Wuxi, 214100, Jiangsu, P.R.C Number (Lab code for CE license): 0123 Technical documentation holder: Suzhou Cleva Electric Appliance Co.,Ltd.
Page 20
After sales helpline number: 08456 400 800 Spare parts purchases: www.argosspares.co.uk...