Maytronics Dolphin Hybrid RS 1 Operating Instructions Manual page 5

Operating above the MAX. may damage the Dolphin Hybrid Cleaner.
CAUTION
Table 1: Flow Indicator
Flow Indication
In satisfactory range
Below MIN.
Above MAX.
Connect the Dolphin Hybrid Cleaner
1
Make sure that the pool pump is switched OFF.
2
Disconnect the Flow Indicator (Drawing E).
3 Make sure the Float is connected on the hose 40 cm
(1.30 ft) above the Dolphin Hybrid Cleaner.
4 Make sure that the hose is entirely under the water
level and is filled with water.
5
Hold the Dolphin Hybrid Cleaner by the handle and
put it in the water. Turn the Dolphin Hybrid Cleaner
upside down to remove any trapped air.
6 Connect the hose end to the Dolphin Hybrid Cleaner
(Drawing F). Make sure that the hose is firmly
connected. Ensure that there is a small space between
the locknut and the pipe.
7 Realese the Dolphin Hybrid Cleaner in the pool.
Restart the pump
Dolphin Hybrid RS 1 - Suction Pool Cleaner
Action
Connect the Dolphin Hybrid Cleaner and begin the cleaning process.
To correct the flow do one or more of the following:
• Make sure that the water level of the pool reaches the skimmer.
• Check that the hose is not twisted or bent near the pool connection.
If it is, use the 90° Adapter.
• Close unused skimmers or main drain. Make sure that the skimmer used
for the Dolphin Hybrid Cleaner is fully opened.
• Remove trapped air from the hose and Dolphin Hybrid Cleaner.
• Tighten connections between Hose Sections.
• Backwash the main filter and clean the skimmer and pump basket.
• Open unused skimmers partially (if closed).
• If the Dolphin Hybrid Cleaner is connected to a dedicated suction line,
adjust its control valve on the pool pump.
• If the Dolphin Hybrid Cleaner is connected to a skimmer, reduce the
suction on the pool pump.
E
max min
Operating Instructions
|
F
3
6
5