Misc Issues; Lost Key - Currie tech E3 Path+ System Operation Manual

16
System Operation Manual - E3 Path+, Venture, Detour
/16
 Stop using the battery and charger immediately. Check for obvious
Solution
Other issues causing a flashing red LED:
 The temperature of the battery is too high to charge.
 Put the battery and charger in a cool place, then try charging again
Solution
ISSUE: Charger LED indicator stays green when plugged into the battery.
 There is no connection between the charger and the battery.
 Check for damage: battery charging port, charging plug, charging
Solution
 There may be an internal problem with the battery or charger. Bring
 The battery's voltage is too low to be charged.
 Check the battery's charge level as described in this document. If the
Solution

Misc issues

Lost key

If you have lost your keys, note your bike's serial number
(located underneath the frame's bottom
EBCC customer service at (800) 377-4532.
No power from battery
The battery has a user-replaceable fuse located at its
base. The fuse is not installed at the factory; you must
install it before using the bike for the first time.
If the fuse is present but the bike still does not power up,
inspect the fuse; if it is blown out, it can be replaced with
a standard 30-amp automotive fuse.
M19+貨架電池+RPM
external shorts on the charging plug and battery charging port. If no
obvious short exists, the battery or charger may be damaged. Bring
them to your dealer for inspection.
after a few minutes.
cord, and power cord.
them to your dealer for inspection.
battery will not turn on, the battery may be damaged and should be
inspected by your dealer.
bracket) then call
Good Blown
10/29/14