Id Configuration; Camera Control Protocol Setup; Power Connection - Grundig GCH-K0274P Owner's Manual

2 megapixel full hd outdoor motorised dome sdi-camera 18x zoom icr wdr hd-sdi cameras & domes

Table of Contents

4.4. ID Configuration

Please change the Dome Camera's ID if there is more than one Dome Camera in the same network. Use this

switch to change your Motordome Camera's ID by setting the 10-bit dip switch. For instance, if the camera's ID is

006, set the SW 8 and SW 9 to "ON", the rest to "OFF," as shown below.

For switch configuration details, please refer to the Switch Settings Index Table (Chapter 6) in this manual.

NOTE: No two Dome Cameras should be given the same ID, otherwise a communication conflict may occur.

Define the protocol you are going to use based on the devices of your surveillance system. Generally, the use of

one protocol is recommended even if the devices are provided from different manufacturers. Please refer to the

table below for all supported protocols with their matching switch numbers and baud rate and choose a protocol

for your Motordome Camera.

The table below shows various protocols with their matching switch numbers and baud rates.

Use the 6-bit dip switch (Camera Control Protocol Switch) to set your camera's control protocol and its baud rate.

Please refer to the illustrations below for power connector definition before wiring.

English

Table of Contents