Table of Contents
Advertisement
8
Communication procedure
8.1
ARL2300 communication protocol
TCP is used for control data communication between ARL2300 and the client software (client
PC).
8.2
TCP receiver control port
The receiver control and the ARL2300 control are done with the following TCP control port.
If the TCP connection procedure has been successful, ARL2300 is sending a "230 Welcome"
message to the client PC. Starting from that moment, the receiver is under remote control.
If you are using a terminal software, you can now try to send commands such as RX, RF, etc...
The command should be terminated by <CR> or <CR><LF>. All responses from receiver are
terminating by <CR><LF>.
Three digits of result code are added to each message from the ARL2300. If the blank character
(blank code) has been added immediately after the result code, the ARL2300 send a simple
message and wait for the data from client.
TCP communication chart (command names omitted)
21
Advertisement
Table of Contents
