Front Panel Power State - AOR ARL2300 User Manual

5

Front panel power state

Once all cables are connected as explained in chapter 4 "Connection to AR2300/AR5001D
receiver", you can switch on the receiver. Switching on the receiver will at the same time power
the ARL2300.
Right after power is on, the red STA-L led will be lit. After approx. 1 minute, ARL 2300 will enter
in stand-by mode, the red STA-L led will go off and the green STA-A will be lit. The time necessary
to enter the stand-by mode might vary depending on the network environment.
■ARL2300 LED status indicator
Right after powering on, initialize time
Initializing has ended, stand-by mode
Connected to client, but no transmission to client
Connected to client, with transmission to client
Firmware download & installation
ARL2300 status
Power is off
STA-L（red LED）
off
on
off
on
on
Combination of both ON and both flashing
9
STA-A（green LED）
off
off
on
on
flashing