Connector Panel Layouts - ALLEN & HEATH MixWizard WZ3 12M User Manual

The Console Connectors
ALLEN&HEATH
INSERT INSERT INSERT
16 15 14
IN IN IN
SPLIT SPLIT SPLIT
EXT MONITOR IN
R L
R L
MONITOR
OUT
USER OPTION PORT A
USER OPTION PORT B
IN
2= +
LIFT
SPLIT
To other channels
12
INSERT INSERT INSERT INSERT
13 12 11 10
IN IN IN IN
SPLIT SPLIT SPLIT SPLIT
INSERT INSERT INSERT
12 11 10
OUT OUT OUT
EXTERNAL DC IN
BACKUP SUPPLY
ONLY USE RECOMMENDED ALLEN&HEATH POWER SUPPLY.
REFER TO USER GUIDE FOR DETAILS.
CHANNEL INPUT
microphone or line level signals. For very hot mic or for line signals press
the channel PAD (LINE) switch. For unbalanced sources use a cable or
adapter that connects XLR pin 3 to pin 1.
WARNING: Do not connect unbalanced sources or cables to
48V
the XLR input when 48V phantom power is selected. To avoid loud
clicks always turn the channel off by pressing MUTE when switching
+48V on or off, and when plugging or unplugging cables.
BUILT-IN MIC SPLITTER
XLR input directly through to an XLR output to send the signal to another
console such as Front-of-House or recording. The mic signal can feed the
monitor and the FOH console at the same time. Connect the split outputs
to the multicore feeding the FOH console using XLR cables.
NOTE: Phantom power can be switched from either the monitor or
the FOH console. If switched from FOH then make sure GND LIFT is
not selected. If it is necessary to select GND LIFT then phantom
power should be switched from the monitor console. No harm will be
done to the consoles if phantom power is switched from both
consoles at the same time.
GND LIFT
XLR and the split output XLR. Press this if there is a problem with a
venue ground loop causing audible hum when connecting the splitter to
the second console. A single ground lift switch is provided next to CH1
input. This affects the ground connection to all the channel split outputs.
MixWizard WZ 3 12M
INSERT INSERT INSERT
9 8 7
IN IN IN
SPLIT SPLIT SPLIT
INSERT INSERT INSERT
9 8 7
OUT OUT OUT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR.
CAUTION: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE
ATTENTION: REMPLACER PAR UN FUSIBLE STRICTEMENT IDENTIQUE EN VALEURS.
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
ENGINEERED IN ENGLAND BY ALLEN & HEATH LIMITED
Balanced XLR input pin 2 hot.
A passive splitter passes each channel
Disconnects the pin 1 ground connection between the input
INSERT INSERT INSERT INSERT
6 5 4 3
IN IN IN IN
SPLIT SPLIT SPLIT SPLIT
INSERT INSERT INSERT INSERT
6 5 4 3
OUT OUT OUT OUT
FUSE
T630mA L 250V 20mm
REPLACE FUSE WITH SAME TYPE AND RATING.
WARNING: THIS APPARATUS MUST BE EARTHED
Serial No.
3
WZ 12M
User Guide
GROUND LIFT
INSERT INSERT
2 1
IN IN
SPLIT SPLIT
INSERT INSERT
2 1
OUT OUT
AC MAINS IN ~
OFF ON
100 - 240V~ 47-63Hz 45W MAX
0
I
Accepts