Honda 2010 Ridgeline Owner's Manual page 361

10/01/26 19:23:40 31SZA620_360
Compass Zone Selection
In most areas, there is a variation
between magnetic north and true
north. Zone selection is required so
the compass can compensate for this
variation. To check and select the
zone, do this:
Turn the ignition switch to the ON
1.
(II) position.
2. On EX and EX-L models
Press and hold the MENU button
for about 5 seconds until you hear
a beep. The display shows you the
compass setting menu items.
On LX models
Press and hold the RPT button
and TUNE/SOUND knob for
about 2 seconds until you hear a
beep. The display shows you the
compass setting menu items.
3. Turn the selector or TUNE/
SOUND knob to select ''ZONE.''
Press the selector knob to enter
your selection. The display shows
you the currently selected zone
number.
4. Find the zone for your area on the
map (see page 356 ). If the correct
zone is not shown, turn the
selector or TUNE/SOUND knob
to cycle the zone lists up or down.
Compass
ZONE NUMBER
If necessary, press the RETURN
button (on EX and EX-L models)
to return to the previous display.
Pressing the MENU button will
cancel the compass setting mode.
5. Once the correct zone is displayed,
press the selector or TUNE/
SOUND knob. The display then
returns to normal.
CONTINUED
355