Table of Contents
Advertisement
Fuel tank
Shoulder
level
Throttle trigger
Air cleaner
Push
Purge bulb
Fuel return line
RUN
(Open)
START
(Close)
ON
Ignition switch
STOP
Throttle trigger lockout
Starter handle
Choke lever
HANDLING FUEL
AFTER REFUELLING, TIGHTEN FUEL CAP FIRMLY
AND CHECK FOR LEAKAGE. IN CASE OF FUEL
LEAKAGE, REPAIR BEFORE STARTING
OPERATION SINCE THERE IS A DANGER OF FIRE.
•
Never smoke or allow flame or sparks near fuel.
•
Always fill the fuel tank outdoors. Never pour fuel
indoors.
•
Always remove the fuel cap slowly to relieve any
pressure buildup in the tank.
•
Never refuel the engine when it is hot or running.
•
Always use an approved, safe fuel container.
•
It is not permitted to fill fuel above the shoulder
level of fuel tank.
•
After fuelling, always wipe away spilled fuel.
•
Always move at least 3 m away from the fuelling
spot before starting the engine.
•
Never store the unit with fuel in the tank a fuel leak
could start a fire.
STARTING COLD ENGINE
WHEN ENGINE IS STARTED, CONFIRM IF THERE
IS NOT ANY ABNORMAL VIBRATION OR SOUND.
IF THERE IS ABNORMAL VIBRATION OR SOUND,
ASK YOUR DEALER TO REPAIR.
•
Stand the engine upright on a level surface.
•
Place ignition switch in ON (START/RUN) position.
•
Push purge bulb 3 to 4 times (or until fuel is visible
in fuel return line).
•
Shift choke lever to close position (START).
•
Pull starter handle until the engine fires.
•
Shift choke lever to full open position, and if
necessary, start the engine again and allow to
warm up before using.
- The clutch engages at approximately 3500
r/min. Therefore the drill bit may rotate at fast idle
engine speed.
STARTING WARM ENGINE
•
Place ignition switch in ON (START/RUN) position.
•
Pull starter handle until the engine fires.
- Do not use the choke.
9
DANGER
WARNING
Advertisement
Table of Contents
