Starting Cold Engine; Starting Warm Engine; Stopping Engine - Echo EDR-2100 Operator's Manual

Throttle trigger
Air cleaner
Purge bulb
Push
Fuel return line
RUN
(Open)
START
(Close)
On
Stop
choke lever
8
IMPORTANT
Stored fuel ages. Do not mix more fuel
than you expect to use in thirty (30)
days, ninety (90) days when a fuel
stabilizer is added.
Stored two-stroke fuel may separate.
ALWAYS shake fuel container
thoroughly before each use.

STARTING COLD ENGINE

Stand the engine upright on a level
surface.
Place ignition switch in ON (START/RUN)
position.
Push purge bulb 3 to 4 times (or until fuel is
visible in fuel return line).
Shift choke shutter to close position.
(START)
Open throttle trigger to a fast idle.
Pull recoil starter until the engine fires.
Shift choke shutter to full open position,and
if necessary, start the engine again and
allow to warm up before using.
- The clutch engages at approximatery
3,500 r/min. therfore the cutter may rotate
at fast idle engine speed.

STARTING WARM ENGINE

Place ignition switch in ON (START/RUN)
position.
Pull starter handle until the engine fires.
- Do not use the choke.

STOPPING ENGINE

Set throttle trigger in idle position.
Place ignition switch in STOP position.
NOTE
When engine does not stop, shift choke
shutter to close position.
Check and repair stop switch before
starting the engine again.