Table of Contents
Advertisement
Throttle trigger
Air cleaner
Push
Purge bulb
Fuel return line
RUN
(Open)
START
(Close)
On
Stop
Starter handle
Choke lever
IMPORTANT
Stored fuel ages. Do not mix more fuel than
you expect to use in thirty (30) days, ninety
(90) days when a fuel stabilizer is added.
Stored two-stroke fuel may separate.
ALWAYS shake fuel container thoroughly
before each use.
STARTING COLD ENGINE
•
Stand the engine upright on a level surface.
•
Place ignition switch in ON (START/RUN)
position.
•
Push purge bulb 3 to 4 times (or until fuel is
visible in fuel return line).
•
Shift choke lever to close position (START).
•
Pull starter handle until the engine fires.
•
Shift choke lever to full open position,and if
necessary, start the engine again and allow to
warm up before using.
- The clutch engages at approximately 3,500
r/min. Therefore the drill bit may rotate at fast
idle engine speed.
STARTING WARM ENGINE
•
Place ignition switch in ON (START/RUN)
position.
•
Pull starter handle until the engine fires.
- Do not use the choke.
STOPPING ENGINE
•
Set throttle trigger in idle position.
•
Place ignition switch in STOP position.
NOTE
When engine does not stop, shift choke lever to
close position.
Check and repair ignition switch before starting
the engine again.
8
Advertisement
Table of Contents
