Putting Into Storage; Maintenance - Gardena EasyCut Li-18/23 Operating Instructions Manual

Lengthening of the filament
(automatic):

6. Putting into Storage

Storage:
Disposal:
(in accordance with
RL 2012/19/EU)
Disposal of
batteries:

7. Maintenance

DANGER!
A clean cut is achieved only with the maximum filament
length.
The cutting filament
filament cassette comes to a standstill after switch off.
V
As the filament can only be lengthened in small increments, it can
U
be necessary in some cases to repeat the switch-off / switch-on
action several times (up to 6 times). Important is that the filament
cassette comes to a complete standstill each time.
The cutting filament has been sufficiently lengthened when,
after switch-on, it audibly strikes the filament limiter
The filament cassette has to be replaced (GARDENA Replacement
Filament Cassette Art. No. 5306) when the cutting filament has
been used up.
Store out of the reach of children.
1. Charge battery.
2. Store your Turbotrimmer in a dry place where it is protected
from frost.
Recommendation:
The trimmer can be suspended by the handle.
The trimmer head is not placed upon any unnecessary strain
if stored in a suspended manner.
The product must not be added to normal household waste.
It must be disposed of in line with local environmental regulations.
The GARDENA Trimmer contains lithium-ion batteries that should
not be discarded with normal household waste at the end of their
life.
Li-ion
Important:
Please return the lithium-ion batteries to your GARDENA dealer
or dispose of them properly at a public recycling centre.
1. Discharge lithium-ion batteries completely.
2. Dispose of lithium-ion batteries properly.
There is a risk of injury from the cutting filament!
v Remove the battery immediately before maintenance!
Risk of injury and risk of damage to property!
v Never clean the trimmer with water or with a water jet
(in particular a high-pressure water jet).
is lengthened automatically when the
U
U
.
V
19