Gardena EasyCut Li-18/23 Operating Instructions Manual page 7

z
Setting the trimmer to body
height:
h
o
1
t
Adjusting the plant guard:
Starting the trimmer:
p
18
Working position 1:
For standard trimming.
Working position 2:
1. Press the foot pedal
desired working position.
2. Release the foot pedal
CAUTION! Avoid contact between the ground and the trimmer
head in working position 1 + 2.
Setting the shaft length:
v Loosen the clamping sleeve
desired shaft length and re-tighten the threaded collar
The clamping sleeve
prevent the shaft from being moved.
Setting the additional handle:
v Pull the lock
set the additional handle
release the lock
If the trimmer is correctly set to the body height, the posture
is upright and the trimmer head in working position 1 is tilted
forwards slightly.
v Hold the trimmer by the handle
such a manner that the trimmer head is tilted forwards slightly.
Working position
v Turn plant guard
until it locks into place.
Switching the trimmer on:
1. Press and hold the safety lock
button
2. Release the safety lock
a Switching the trimmer off:
v Release the start button
and lower the shaft downwards into the
z
and allow the shaft to engage.
z
t
must be fastened firmly enough to
t
belonging to the additional handle
o
to the desired incline and
h
.
o
ö
through 90° into the required position
ö
on the handle.
a
again.
p
on the handle.
a
, extend the handle
1
,
h
and additional handle
1
ö
Parking position
and then press the start
p
to the
.
t
in
h