Advertisement
9. CONNECT REAR FLEXIBLE HOSE
2010 Toyota Prius
(a) To compensate for pad wear when reusing the pad, use
SST to turn the piston to the position where the protrusion
on the pad lines up properly with the piston groove.
Retract
Clockwise
SST: 09960-10010
09963-00400
NOTICE:
Place the disc between the 2 brake pads and determine the
piston return value.
(b) Hold the rear disc brake cylinder pad guide pin, and
install the rear disc brake cylinder assembly to the rear disc
brake cylinder mounting with the 2 bolts.
Text in Illustration
*1
*2
Torque: 34 N·m (350 kgf·cm, 25ft·lbf)
x
Install the rear disc brake cylinder assembly while
holding both of the rear disc brake pads because the
anti-squeal springs may fall off the rear disc brake pads.
x
Be sure that the anti-squeal springs are installed to the
rear disc brake pads.
(a) Connect the rear flexible hose to the rear disc brake
cylinder assembly with a new union bolt and a new gasket.
Torque: 33 N·m (340 kgf·cm, 25ft·lbf)
HINT:
Install the flexible hose lock securely into the lock hole in
Extend
Counterclockwise
Hold
Turn
Repair Manual
Advertisement
