Advertisement
REASSEMBLY
1. TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG
HINT:
Fully tighten the rear disc brake bleeder plug after bleeding any air left in the system.
2. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP
3. INSTALL PISTON SEAL
(b) Install the piston seal to the rear disc brake cylinder assembly.
NOTICE:
Securely install the piston seal to the groove of the rear disc brake cylinder assembly.
4. INSTALL CYLINDER BOOT
2010 Toyota Prius
(a) Apply a light layer of lithium soap base glycol grease to
the entire circumference of a new piston seal.
(a) Apply a light layer of lithium soap base glycol grease to
the entire circumference of the rear disc brake piston and a
new cylinder boot.
Repair Manual
Advertisement
