Page 2
User Manual for your Baumatic SPECTRUM 68 cm Decorative Chimney Hood NOTE : This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference;...
IMPORTANT SAFETY INFORMATION 5 – 7 Specifications of your cooker hood Product dimensions Specifications Optional extras Using your Baumatic cooker hood 9 - 10 Before first use To use your cooker hood Setting the motor speed The cooker hood lights...
ENVIRONMENTAL NOTE Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useless. Cut the cable off directly behind the appliance to prevent misuse. This should be undertaken by a competent person.
IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Customer Care Department.
Page 6
o When installed between adjoining wall cabinets, the cabinets must not overhang the hob. o The edges of the cooker hood are sharp – be mindful of this as you handle your appliance, especially during installation and cleaning. DO NOT CLEAN IN BEHIND THE GREASE FILTERS! o If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the sealed or balanced flue type.
Page 7
o The manufacturer refuses to accept any responsibility for damages arising to the hood or it catching on fire, from a failure to observe the fire safety advice contained in this instruction booklet. o Remember that when in extraction mode, your cooker hood is removing air from your room.
Specifications of your cooker hood PRODUCT DIMENSIONS: Height: 375 mm Width: 680 mm Depth: 470 mm Your cooker hood is fitted with: o Electronic pushbutton control operation o 3 Speeds o 1 Washable aluminium grease filter o 2 LED lights o Perimeter extraction o Ambient lighting o Extraction or recirculation...
Using your Baumatic cooker hood Before first use IMPORTANT: THIS PROCESS MUST BE FOLLOWED BEFORE THE COOKER HOOD IS USED FOR THE FIRST TIME. o You should use a good quality stainless steel cleaner and polish on ALL of the stainless steel areas of your cooker hood, before it is used for the first time.
etting the motor speed Press the speed increase button to switch the hood on. o The motor has three speeds, low, medium and high. o You can use the speed increas e and decrease buttons to choose an appropriate motor speed. o To turn the cooker hood off press the minus button once when the motor is set at the lowest speed.
Baumatic cooker hood IMPORTANT: BEFORE CLEANING, ALWAYS ENSURE THAT HAVE SWITCHED YOUR COOKER HOOD OMNI-POLAR WITCH, SET AT THE WALL FROM THE CABLE. Cleaning Clean the external parts of your cooker hood with mild liquid detergent and a new damp cloth.
aintenance Removing and cleaning the grease filter o Open the cover (1) that sits over t grease filter (as sho wn in the line drawing opposite). o Remove the grease filter (2) by pulling down handle pulling it away from the cooker hood. o Soak the grease filter in hot water and washing up liquid for least 5 minutes (or longer if the grease build up is severe).
Changing a light bulb IMPORTANT: BEFORE ATTEMPTIN G TO CHANGE A LIGHT BULB, YO U MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FROM YOUR MAINS SUPPLY. o Prior to touching the light bulbs ensure they are coo led down. o First unscrew the 4 screws securing the glass panel on the side of the appliance where you a re changing the bulb.
Fitting the carbon filters If the applian ce is to be used in recirculation mode then it is necessary to fit carbon filters. This will help to absorb unpleasant odours caused by cooking. IMPORTANT: BEFORE ATTEMPTING TO FIT OR REMOVE THE CARBON FILTERS, YOU M ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FROM YOUR MAINS SUPPLY.
Installation IMPORTANT: Before installation and usage read all the instructions and make sure that the voltage (V) and the frequency (Hz) indicated on the rating plate are exactly the same as the voltage and freq uency in your ho me. The rating plate can be found behind the grease filter.
The blue wire must be connected to the terminal marked “N” (neutral), or coloured black. The brown wire must be connected to the terminal marked “L” (live), or coloured red. Before beginning installation o Check that the product purchased is of a suitable size for the chosen installation area.
Please note that the styles of cooker hood shown in th line drawings in the following pages are sometimes different t o the shape of the SPECTRUM. However the installation method shown is correct and MUST be followed. IMPORTANT: YOUR COOKER HOOD...
Page 18
1) Remove the metal grease filter. 2) Position the hood against the wall that you are intending to ins tall it on and mark the position of the support holes that are to be dr illed (as hown in the figure pposite).
Page 19
3) Using a drill bit with an 8 mm diameter, make holes in the wall on the positions that you have marked in step 4) Insert rawl plugs into all of the holes that you have drilled. 5) Fasten the support screws halfway in, le aving them 10 mm out of the wall.
7) Fully tighten the support screws (A) and then screw the anchoring screws (B) through the relevant holes in the cooker hood. Fully tighten the anchoring screws into the wall. Connecting to external ducting 8) Connect the coupling to the top of the cooker hood, and then connect a 125 mm ducting hose to the coupling (please note that the ducting hose is not supplied with the appliance).
Fitting the optional chimney sections (CQ5SS) 9) Take the two chimney sections (C) and (D). o Rest the bottom of chimney section (C) on the top of the hood. You should take care to position the tabs on the chimney section into the rear of the hood.
Page 22
11) Take the flat bracket (E) and place it between the two pencil marks that you made in step 9 o Keeping the bracket in contact with the wall, use a pencil to mark on the wall the anchoring holes that are cut out of the bracket. 12) Using an 8 mm drill bit, drill out two holes on the pencil markings that you made in step 11.
o Slide chimney section (D) inside of chimney section (C). Then secure the L shaped bracket to the wall, using the same method as you have just used to secure the lower bracket. 13) Lift chimney section (D) up to the ceiling and secure it to the L shaped bracket using the screws provided.
Troubleshooting IMPORTANT: If your cooker hood appears not to be operating properly, before contacting Baumatic Customer Care Department, please refer to the checklist below. My cooker hood will not start. o Check that the hood is connected to the electricity supply o Check that the fan speed control is set correctly.
Page 25
Or any installation other than the one specified by Baumatic Ltd. has been completed. Please refer to the conditions of guarantee that appear on the warranty card that you receive with the appliance.
BC005 Stainless Steel Cleaner and Protector (250 ml) o BC007 E-Cloth – General Purpose Cloth o BC008 Microwave Cover To order a Baumatic consumable product please call 0123 5437 244 and quote the product code. You can also order online from eshop.baumatic.co.uk...
Need help?
Do you have a question about the Spectrum and is the answer not in the manual?
Questions and answers