HP Pavilion 10 Maintenance And Service Manual page 41

Hide thumbs Also See for Pavilion 10:

Table of Contents

Open the computer as far as possible and turn the computer on its side. Remove the two Phillips

2.5×5.0 screws (1), and (2) from the display hinges.

Slide the display assembly (3) to remove it.

CAUTION:

routed and arranged properly.

Failure to properly route the antennas can result in degradation of the computer's wireless

performance.

Replace the panel if this is a whole unit touchscreen replacement by reversing these

procedures. The whole unit panel replacement is complete.

NOTE:

If you are replacing an assembly component for a non-touchscreen display, continue the

steps below.

Display assembly

Remove the display assembly:

Place the computer upright and open as far as possible.

Remove the display screw covers (1) and remove the two Phillips 2.5×2.5 screws (2).

When installing the display assembly, be sure that the wireless antenna cables are

Component replacement procedures

Table of Contents