Page 1
Slim Use & Care Guide Get the most from your new Keurig brewer ®...
Page 2
Before You Brew Plug & Place Rinse & Fill Power Button Remove packing tape from brewer. Remove the water reservoir lid, then lift the reservoir straight up Plug into a grounded outlet. Place to remove it. mug on drip tray. Rinse reservoir with fresh water and fill to the MAX FILL line.
Page 3
Brew Your First Cup Place Mug & Pod Brew & Enjoy! Place a mug on the drip tray. If using The three brew size buttons will blink. a travel mug, remove the drip tray STRONG Select your brew size, then press the Brew Button and place the mug on the drip tray blinking brew button.
Regular cleaning keeps your brewer running smoothly. Always be sure to turn off and unplug your brewer before cleaning. Brewer Exterior Keep your Keurig® brewer looking its best by cleaning the exterior from time to time. Just clean with a damp, soapy, lint-free, non-abrasive cloth.
Page 5
Water Reservoir The water reservoir should be cleaned periodically by wiping the inside of the reservoir and underside of the lid with a damp, non-abrasive, lint free cloth. Do not dry the inside of the water reservoir with a cloth as lint may remain.
Page 6
K-Cup® Pod Holder To remove the K-Cup® pod holder from the brewer, lift the handle and grasp STRONG the top of the K-Cup® pod holder with one hand while pushing up on the bottom of the K-Cup® pod holder from underneath with the other until it releases.
Page 7
Gently move it around to loosen any coffee grounds. Lower the handle completely and run two water-only brew cycles. Do not insert a K-Cup® pod. TIP: Refer to support.keurig.com for video instructions on cleaning the entrance/exit needles.
K-Cup® pod holder. Please allow approximately NOTE: The cleaning action of Keurig® Descaling Solution may result in a “foam” dispensed from the brewer. This 15-20 minutes for the descaling procedure. is natural, as the solution is reacting with the scale inside. For a brewer that is heavily scaled, the brewer may not fill properly after the descaler is added.
Troubleshooting Grounds in Your Coffee Brewer Does Not Have Power or Shuts Off Grounds may have gathered in the exit or entrance needles • Make sure that the power button has been turned on. and can be cleaned using a straightened paper clip or similar •...
Page 10
Helpful Hints Have Questions? Water quality varies greatly. If you notice an undesirable We’re here to help. Visit support.keurig.com for taste in your beverage (such as chlorine or mineral tastes), step-by-step videos on cleaning, descaling, and more. we recommend using bottled or filtered water. Do not use distilled water.
God. that you register your brewer on keurig.com/new so that your purchase information will be stored in our system. Keurig will, at its OTHER LIMITATIONS option, repair or replace a defective brewer without charge upon its receipt of proof of the date of purchase.
Page 12
B. K-Cup® Pod Holder (B and C are the K-Cup® Pod Holder Assembly) C. Funnel D. K-Cup® Pod Assembly Housing E. Drip Tray Plate F. Drip Tray G. Drip Tray Base H. Water Reservoir Lid I. Water Reservoir For replacement parts, please visit www.keurig.com...
Page 13
Coffeehouse taste in your own home. FIND YOUR PERFECT POD With over 75 brands and hundreds of varieties, find your match at keurig.com/new DC0000003548 REV A...
Need help?
Do you have a question about the K-Slim Slim and is the answer not in the manual?
Questions and answers