Advertisement
Using Your Kambrook Pedestal Fan
23.
Tighten the small screw and nut
together (See Fig. 15).
Operating your Arctic
Pedestal Fan
Plug the cord into a 230V or 240V
power point and switch on.
The fan has 3 speed settings. To adjust
the flow of air, turn the fan speed
selection dial located at the back of
the fan motor head to the preferred
speed setting – 'LO', 'MED', 'HI'. To turn
Off, turn the fan speed selection dial
to the 'OFF' position.
WARNING: Never insert
fingers, pencils or any
other objects through
the guards whenever the
power plug is connected,
in particular while the fan
is switched on.
12
Setting the Oscillation
The oscillation works in all air flow
settings.
Press the 'SWING' button down to
activate. The fan will begin to oscillate
from side to side.
Lift the 'SWING' button to stop the fan
from oscillating.
NOTE: The 'SWING' button is
Fig. 15
located behind the rear grille,
on the motor head.
Adjustable Tilting Head
The Arctic Pedestal Fan incorporates
an adjustable tilt head for directional
air coverage.
To adjust the angle of the head,
loosen the tilt control knob located
beneath the motor head, tilt the head
to the required angle, then re-tighten
the control knob.
Adjustable Height
The fan height can be manually
adjusted. Simply loosen the height
adjustment knob on the extension
tube of the fan, then adjust to the
required height. Re-tighten the height
adjustment knob when the desired
height has been reached.
Continued...
Advertisement
