Advertisement
16.
Thread the motor head through
the centre hole of the rear
grille, placing the rear grille into
position. Make sure that the
carry handle on the back of the
rear grille is located above the
motor head.
17.
Ensure the rear grille mounting
holes are aligned with the
mounting holes on the motor
head and fix the grille into
position with the 4 small screws
and washers provided (See Fig.
12). Make sure that the rear grille
has not slipped off the mounting
holes before tightening the
screws.
NOTE: When positioning the
rear grille on the motor shaft,
always ensure the carry handle
on the grille is positioned in the
upright position.
18.
Slightly loosen the securing
screw located on the back
of the fan blades so you can
insert the blades onto the motor
shaft. Make sure the blades are
inserted onto the motor shaft
with the securing screw side
facing the rear grille.
19.
20.
21.
Fig. 12
22.
Align the screw with the groove
in the motor shaft. Tighten the
screw making sure the fan
blades are secure to the motor
shaft and the blades are able to
move freely (See Fig. 13).
Loosen the small screw at the
bottom of the front grille by
hand. Locate the positioning tab
on the top end of the front grille
and slot into the top of the rear
grille.
Thread the screw through the
small holes at the bottom of both
the front and rear grilles and
loosely secure the screw using
the nut provided.
Secure the front and rear grille
by snapping shut the securing
clips over the edges of both
grilles (See Fig. 14).
Fig. 13
Fig. 14
11
Advertisement
