Page 1
Kambrook - Australia Kambrook - New Zealand Building 2, Port Air Industrial Estate Private Bag 94411 1A Hale Street Botany, Manukau Botany NSW 2019 Auckland 2163 Australia New Zealand Customer Service Line 1300 139 798 Customer Service Line/ Customer Service Fax 1800 621 337...
Page 2
Arctic 40cm Gunmetal Pedestal Fan Instruction Booklet KPF443...
Page 3
In the event that you need some assistance with your Kambrook appliance, please contact our Customer Service Department on 1300 139 798 (Australia) or 0800 273 845 (New Zealand). Alternatively, visit us on our website at...
Page 4
Contents Kambrook Recommends Safety First Your Kambrook Arctic 40cm Gunmetal Pedestal Fan Using Your Kambrook Fan Care, Cleaning and Storage...
Page 5
IMPORTANT: Please retain your instruction book for future use. At Kambrook, we believe that safe performance is the first priority in any consumer product, so that you, our valued customer can confidently use and trust our products. We ask that any electrical appliance that you use be operated in a sensible fashion with due care and attention placed on the following important operating instructions.
Return the entire appliance to the nearest or heaters. authorized Kambrook service centre for • Position the appliance at a minimum examination and / or repair. distance of 20cm away from walls, curtains • Any maintenance other than cleaning...
Page 7
Your Kambrook Arctic 40cm Gunmetal Pedestal Fan Insert 1: Fan speed selection dial with choice of 3 speed settings Swing button turns the oscillation on and off to disperse the air throughout the room Convenient carry handle for easy portability...
Page 8
Main Image: 40cm metal fan blades Front and rear metal grilles Adjustable height pedestal extension tube with knob Anti-topple base for stability Parts List Not Shown: • Bolt, spacer, large washer and weight for fitting base • 4x small screws and washers to fix the rear metal grille to the motor head •...
Page 9
Using Your Kambrook Pedestal Fan Before First Use Fully insert the long screw into the square hole of the tilt Remove any promotional material adjustable head through the from fan. extension tube and the other end of the tilt adjustable head (See Fig.
Page 10
Secure and tighten the long Unscrew the bolt at the bottom screw with the nut knob of the extension tube and fit the (See Fig. 4). extension tube into the aperture located at the centre of the base (See Fig. 6). Fig.
Page 11
Using Your Kambrook Pedestal Fan Continued... Place the spacer at the centre Loosen the height adjustment of the base between the base knob on the extension tube weight and the protrusion of the and pull up the inner extension extension tube (See Fig. 8).
Page 12
Thread the motor head through Align the screw with the groove the centre hole of the rear in the motor shaft. Tighten the grille, placing the rear grille into screw making sure the fan position. Make sure that the blades are secure to the motor carry handle on the back of the shaft and the blades are able to rear grille is located above the...
Page 13
Using Your Kambrook Pedestal Fan Continued... Setting the Oscillation Tighten the small screw and nut together (See Fig. 15). The oscillation works in all air flow settings. Press the 'SWING' button down to activate. The fan will begin to oscillate from side to side.
Care, Cleaning and Storage Always switch the fan off, switch off at the power outlet and unplug prior to cleaning the housing, base, grilles and blades. To clean the outside of the fan, wipe the exterior with a soft, damp cloth. Never use an abrasive cleaner.