Page 3
Insignia Soundbar with Wireless Subwoofer 6 Clean only with dry cloth. 7 Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. 8 Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Page 4
Insignia Soundbar with Wireless Subwoofer 22 Batteries should not be exposed to excessive heat such as sunshine, fire, or the like. Warning Danger of explosion if the remote control battery is incorrectly replaced. Replace only with the same or equivalent type.
Insignia Soundbar with Wireless Subwoofer Package contents Soundbar HOLD THE LEVEL TO THE TOP EDGE OF THIS TEMPLATE Hold this template in the location you want, Wall Determine where you would like to mount Wall TOOLS NEEDED and use a level to level it, then tape it to the...
Insignia Soundbar with Wireless Subwoofer Features Side view Item Description +/– Press to increase or decrease the volume. (source) Press repeatedly to cycle through the available sound sources: button • Source 1 - Optical • Source 2 - RCA • Bluetooth (Power) Press to turn on the soundbar.
Insignia Soundbar with Wireless Subwoofer Front view LED indicator LED Color Action Description Solid - Standby/power off (remains on in standby mode) - Mute Flashes (not source dependent) Green RCA or Optical source selected Lights for 10 seconds - Power on...
Insignia Soundbar with Wireless Subwoofer Back view Item Description Hanging brackets Use to hang the soundbar on a wall. Pairing button Used to pair the soundbar to subwoofer if not automatically connected when turned on. DC IN jack Connect the AC adapter to this jack to power the soundbar.
Insignia Soundbar with Wireless Subwoofer Remote control Item Description (Power) Press to turn on the soundbar. Press again to put the soundbar into standby mode. SOURCE - OPTICAL Press to select the digital optical sound source for your soundbar. SOURCE - RCA Press to select the RCA sound source for your soundbar.
Insignia Soundbar with Wireless Subwoofer Using the remote control 1 Remove the plastic tab from the battery compartment before using the remote control for the first time. 2 Point the remote control directly at the IR sensor on the front of the soundbar.
Insignia Soundbar with Wireless Subwoofer Audio Jack Type Cable Quality Digital Optical cable (not included). Best See “Digital Optical connection (best)” on page 11. RCA audio cable (included). See “RCA Good connection (good)” on page 13. 3.5 mm audio cable. See “3.5mm Good connection (good)”...
Page 12
Insignia Soundbar with Wireless Subwoofer 2 Change the device’s audio output to 'PCM' format (typically found in audio settings). Refer to the documentation that came with your audio source device for more information. 3 Go to "Third step - Connecting the AC adapter" on page 13.
Insignia Soundbar with Wireless Subwoofer 3.5mm connection (good) 1 Connect the right-angled connectors of the RCA audio cable to your soundbar. 2 Connect the other ends of the cables to the RCA to 3.5 mm adapter, then connect the other end to the headphone or AUX Output on your audio source device.
Insignia Soundbar with Wireless Subwoofer 2 Plug the other end of the AC adapter into a power outlet or surge protector. Fourth step - Connecting the subwoofer • Your subwoofer receives a wireless audio signal from the bar, so all you need to do is plug in the power cord.
Page 15
For additional information on pairing your device, refer to your devices’ documentation. 3 On your Bluetooth device, select “NS-SB515” from the device list. Repeat step 2 if “NS-SB515” is not displayed. 4 If a PIN code is requested, enter “0000. ”...
Select “NS-SB515” on your Bluetooth device. Note If a device does not automatically reconnect, you may need to reselect “NS-SB515” on your Bluetooth device. Connecting to a different device 1 On your Bluetooth device you are currently connected to, turn off the Bluetooth function or unpair the soundbar in your Bluetooth device list.
Page 17
Insignia Soundbar with Wireless Subwoofer • You can set the soundbar on a flat surface. -OR- • You can mount the soundbar on a wall. • You can place the subwoofer anywhere in the room because the low frequency sound is non-directional.
Insignia Soundbar with Wireless Subwoofer Mounting your soundbar on a wall (optional) You will need: HOLD THE LEVEL TO THE TOP EDGE OF THIS TEMPLATE Hold this template in the location you want, Wall Wall TOOLS NEEDED Determine where you would like to mount...
Insignia Soundbar with Wireless Subwoofer 6 Secure two screws (not included) to the wall or wall anchors (if required). The screws must protrude from the wall by about 1/4” (6.35 mm). Use a #10 wood screw (or similar), 1 1/2" (3.8 cm) in length. The screw width must be about 3/16”...
Insignia Soundbar with Wireless Subwoofer 5 Press the (Power) button again to turn off your soundbar. The standby indicator lights red. Maintaining your soundbar Replacing the remote control battery 1 Squeeze the battery tray’s sides together and slide it out of the remote control.
Insignia Soundbar with Wireless Subwoofer Troubleshooting Check this list for a possible troubleshooting solution before calling for service. Problem Possible Solutions The power does not come on. • Make sure that the AC adapter is securely plugged into the power outlet and the soundbar.
Page 22
• Make sure that your Bluetooth device is not connected to any other device. • Make sure that you have selected “NS-SB515” on your Bluetooth device. My Bluetooth device keeps • Shorten the distance between your soundbar and your Bluetooth unpairing device.
Insignia Soundbar with Wireless Subwoofer Specifications Designs and specifications are subject to change without notice. Power output 60 W total : left and right channel 15 W, subwoofer 30 W, 1% THD Frequency response 150 Hz ~ 15 kHz Dimensions (approx.) Soundbar: 37.1 x 3.5 x 2.5 in. (94.3 x 9.0 x 6.5 cm) Subwoofer: 12.4 x 8.1 x 11.9 in.
Page 24
Insignia Soundbar with Wireless Subwoofer www.insigniaproducts.com...
Products and parts replaced under this warranty become the property of Insignia and are not returned to you. If service of Products or parts are required after the Warranty Period expires, you must pay all labor and parts charges. This warranty lasts as long as you own your Insignia Product during the Warranty Period.
Page 26
FOR THE BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT, INCLUDING, BUT NOT LIMITED TO, LOST DATA, LOSS OF USE OF YOUR PRODUCT, LOST BUSINESS OR LOST PROFITS. INSIGNIA PRODUCTS MAKES NO OTHER EXPRESS WARRANTIES WITH RESPECT TO THE PRODUCT, ALL EXPRESS AND...