Connecting The Multiple Units With The Lan - Sony TRIMASTEREL BVM-F250 Operation Manual

with the controller to the DC 5V/12V IN connector of
the controller.
Connecting the Multiple Units with
the LAN
The controller controls up to 32 monitors. Up to four
controllers are connected to one monitor in single mode.
Note
The controller cannot control monitors in another
subnetwork.
NETWORK switch
tSet to LAN.
BVM-F250
LAN (10/100)
connector
AC adaptor (supplied
with the BKM-16R)
Switching hub
(recommended: with
AUTO MDI/MDI-X
function)
DC 5V/12V IN
connector
Controller
(BKM-16R)
NETWORK switch
tSet to LAN.
1
Turn off the MAIN POWER switch of the monitor
before connecting the units.
2
Connect to the network by using a 10BASE-T/
100BASE-TX cable (shielded-type, optional).
BVM-F250
LAN (10/100)
connector
LAN (10/100)
connector
Notes
• When an optional LAN cable is connected, use a
shielded-type cable to prevent a malfunction due to
noises.
• We recommend to use an optional switching hub
with auto selection function (AUTO MDI/MDI-X)
of a straight/cross cable.
3
Connect the output cable on the AC adaptor supplied
with controller to the DC 5V/12V IN connector of the
controller.
Note
When the multiple units are connected, set for the LAN
before setting the NETWORK switch to LAN.
For the LAN setting, see "Setting for the LAN to
Connect the Multiple Units" on the Operation Manual.
4
Set the NETWORK switches of each monitor and the
controller to LAN.
81
Connections (BVM-F250)