Connecting - Sony XAV-63 Operating Instructions Manual

4
Operate the Bluetooth device to
search for this unit.
A device list appears on the display of the
device. This unit is displayed as "Sony
Automotive."
DR-BT30Q
Sony
Automotive
XXXXXXX
5
If passkey* input is required on the
display of the device, input "0000."
XXXX
This unit and the Bluetooth device memorize
each other's information, and when pairing is
made, this unit is ready for connection to the
device.
6
Operate the Bluetooth device to
connect to this unit.
"Bluetooth device connected." appears and
connection is complete. "
appears when the connection is made.
Notes
• While connecting to a Bluetooth device, this unit
cannot be detected from another device. To enable
detection, enter the pairing mode and search for this
unit from another device.
• It may take time to pair or connect.
• Depending on the device, the confirmation display of
the connection appears before inputting the
passkey.
• The time limit for inputting the passkey differs
depending on the device.
• This unit cannot be connected to a device that
supports only HSP (Head Set Profile).
When the ignition is turned to on with the
Bluetooth signal activated, this unit searches for
the last-connected Bluetooth device, and
connection is made automatically if possible.
This chapter explains how to connect manually
to registered Bluetooth devices.
Before starting, be sure to activate the Bluetooth
signal both on this unit (page 37) and the other
Bluetooth device.
Connecting a cellular phone
1
Input passkey.
2
"0000"
Connecting to the cellular phone
last-connected from this unit
1
2
" or " "
Note
Some cellular phones require permission to access
their phonebook data during handsfree connection to
this unit. Obtain permission via the cellular phone.
Tip
With Bluetooth signal on: when the ignition is switched
to on, this unit reconnects automatically to the last-
connected cellular phone. But automatic connection
also depends on the cellular phone's specification. If
this unit does not reconnect automatically, connect
manually.
Connecting an audio device
1
2

Connecting

Make sure the Bluetooth signal of this
unit and the cellular phone is turned
on.
Operate the cellular phone to connect
to this unit.
" " flashes while the connection is being
made, then stays lit while connected.
Make sure the Bluetooth signal of this
unit and the cellular phone is turned
on.
Press (TOP), then touch "BT Phone"
in the top menu.
" " flashes while the connection is being
made, then stays lit while connected.
Make sure the Bluetooth signal of this
unit and the audio device is turned on.
Operate the audio device to connect to
this unit.
" " flashes while the connection is being
made, then stays lit while connected.
33