Installing An Input Adaptor (Bvm-F170) - Sony TRIMASTEREL BVM-F250 Operation Manual

When the BKM-250TG is used, install the Link A signal
to INPUT 1, and the Link B signal to INPUT 2.
For 3D signal analyzing function
Use a 3D-compatible BKM-250TG (with serial number
7300001 or higher) and input the left 3D signal to INPUT 1
and the right signal to INPUT 2.
Installing an Input
Adaptor (BVM-F170)
INPUT 1 1
Loosen two screws and remove the cover of an input
option port on the rear panel of the monitor.
Make sure the MAIN
INPUT 2
POWER switch is turned
off, and disconnect the AC
power cord.
2
Insert the adaptor facing the board as shown below.
3
Push the adaptor in until it is firmly fit into the
connector inside the monitor, then tighten the two
screws to secure the adaptor.
Cover of an input
option port
Board

Installing an Input Adaptor (BVM-F170)

77