Manitowoc SN12 Replacement Instructions

Nugget ice machines cutter head

Hide thumbs Also See for SN12:

Download this manual See also: Installation, Use & Care Manual

Manitowoc SN12/SN20 Model Nugget Ice Machines

1. Disconnect water supply.

2. Remove front panel.

3. Move toggle switch to CLEAN position after the 5 minute delay expires. The evaporator and float

chamber will drain.

4. Disconnect power at electrical disconnect.

Disconnect power to the ice machine at the electrical disconnect, moving

the toggle switch to the off position will not disconnect line voltage.

5. Remove top, left and right side panels.

6. Remove ice chute assembly.

NOTE; if the ice wiper can not be hand removed; place the handle end of a screwdriver against the ice

wiper, then tap the screwdriver (counterclockwise) with a hammer to loosen the ice wiper from the

auger.

Manitowoc Foodservice

2110 South 26

Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA

Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879

Web Site -

www.manitowocice.com

Cutter Head Replacement Instructions

WARNING

REMOVE COVER

REMOVE ICE DAMPER

REMOVE STRAINER

REMOVE ICE WIPER

REMOVE ICE CHUTE

LOOSEN HOSE CLAMP AND

DISCONNECT DRAIN LINE

000004021

Sheet 1 of 2

08/25/08

Page 1 Manitowoc SN12/SN20 Model Nugget Ice Machines 1. Disconnect water supply. 2. Remove front panel. 3. Move toggle switch to CLEAN position after the 5 minute delay expires. The evaporator and float chamber will drain. 4. Disconnect power at electrical disconnect.
Page 2 7. Peel evaporator insulation down to expose Use puller to remove cutter head from auger shaft. NOTE: If the bearing is destroyed or the auger heavily damaged from bearing wear contact the Manitowoc service department @ 1-800-545-5720. 8. Install new cutter head and secure with three bolts removed in step 7. Use removable loctite on bolt threads.

Sn20