Precautions; On Safety; On Installation; Handling The Screen - Sony BVM-F250A Operation Manual

Precautions

On Safety

• Operate the unit only with a power source as specified in
the "Specifications" section.
• A nameplate indicating operating voltage, power
consumption, etc., is located on the rear panel.
• Should any solid object or liquid fall into the cabinet,
unplug the unit and have it checked by qualified
personnel before operating it any further.
• Do not drop or place heavy objects on the power cord. If
the power cord is damaged, turn off the power
immediately. It is dangerous to use the unit with a
damaged power cord.
• Unplug the unit from the wall outlet if it is not to be used
for several days or more.
• Disconnect the power cord from the AC outlet by
grasping the plug, not by pulling the cord.
• The socket-outlet shall be installed near the equipment
and shall be easily accessible.

On Installation

• Allow adequate air circulation to prevent internal heat
build-up.
Do not place the unit on surfaces (rugs, blankets, etc.) or
near materials (curtains, draperies) that may block the
ventilation holes.
• Do not install the unit in a location near heat sources such
as radiators or air ducts, or in a place subject to direct
sunlight, excessive dust, mechanical vibration or shock.
For BVM-F250A only
When installing the installation space must be secured in
consideration of the ventilation and service operation.
• Do not block the ventilation slots, and vents of the fans.
• Leave a space around the unit for ventilation.
• Leave more than 40 cm of space in the rear of the unit to
secure the operation area.
When the unit is installed on the desk or the like, leave at
least 1U (4.4 cm) or more of space above and below the
unit. Leaving 40 cm or more of space above the unit is
recommended for service operation.
Pour le BVM-F250A uniquement
Pendant l'installation, prenez en compte l'espace
d'installation requis pour la ventilation et la maintenance.
• Ne bloquez pas les fentes de ventilation, ni les évents des
ventilateurs.
• Laissez un espace autour de l'appareil pour la
ventilation.
• Laissez plus de 40 cm d'espace à l'arrière de l'appareil
pour délimiter la zone de service.
Lorsque l'appareil est installé sur un bureau ou équivalent,
laissez un espace d'au moins 1U (4,4 cm) au-dessus et en
dessous de l'appareil. Il est recommandé de laisser un
espace de 40 cm ou plus au-dessus de l'appareil à des fins
de maintenance.

Handling the Screen

• The OLED panel fitted to this unit is manufactured with
high precision technology, giving a functioning pixel
ratio of at least 99.99%. Thus a very small proportion of
pixels may be "stuck", either always off (black), always
on (red, green, or blue), or flashing. In addition, over a
long period of use, because of the physical characteristics
of the panel, such "stuck" pixels may appear
spontaneously. These problems are not a malfunction.
• Do not leave the screen facing the sun as it can damage
the screen. Take care when you place the unit by a
window.
• Do not push or scratch the monitor's screen. Do not place
a heavy object on the monitor's screen. This may cause
the screen to lose uniformity.
• The screen and the cabinet become warm during
operation. This is not a malfunction.

On Burn-in

Due to the characteristics of the material used in the OLED
panel, permanent burn-in or reduction in brightness may
occur.
These problems are not a malfunction.
Images that may cause burn-in
• Masked images with aspect ratios other than 16:9
• Color bars or images that remain static for a long time
• Character or message displays that indicate settings or
the operating state
• On-screen displays such as center markers or area
markers
To reduce the risk of burn-in
• Turn off the character and marker displays
Press the MENU button to turn off the character displays.
To turn off the character or marker displays of the
connected equipment, operate the connected equipment
accordingly. For details, refer to the operation manual of
the connected equipment.
• Turn off the power when not in use
Turn off the power if the monitor is not to be used for a
prolonged period of time.
23
Precautions