Installer Status Screen; Week Program - Frico SIReFAEMX Original Instructions Manual

Installer menu
To enter the Installer menu, code 1932 is
entered. Select the digits using the rotary dial
and confirm using the forward arrow.
Main menu
Fan control
System on/off
Installer menu

Installer status screen

Check the settings. The installer status screen
consists of three pages with settings, scroll
using the rotary dial.
>Installer menu
Installer status screen

Week program

Fan settings
Week program
Make settings for week program.
>Installer menu
Installer status screen
Week program
Fan settings
A basic program is pre-entered in SIRe.
Mon-Fri Day from 08:00, Night from 18:00
Sat Day from 10:00, Night from 16:00
Sun Day from 11:00:00, Night from 14:00
To check which program is set for a particular
day, select Check program and then switch
between the days using the rotary dial.
>Installer menu>Week program
New program step
Check program
Change program
SIRe Advanced Fan Heater Electric
Main menu>Installer menu
Enter password
0 0 0 0
(See manual)
>Installer status screen
Functionality mode Adv.
Eco / Comfort mode Comfort
2°C
Program
FH4 FF
FF
002
FF
Check program
Mon Tue Wed Thu Fri Sat Sun
08:00 Day (1)
18:00 Night (2)
To check which days a certain program is
active, select a week day by pressing the
forward arrow, the program is marked and
those days that the program is used will be
underlined, switch between the programs for
a particular day using the rotary wheel.
Check program
Mon Tue Wed Thu Fri
08:00 Day (1)
18:00 Night (2)
To add program step, select New program
step. Confirm your selection with the forward
arrow. Select Day, Night or Off (if the unit
should not be in operation), set the time
for switch on and then for which days the
program applies, then go to End to finish.
>Installer menu>Week program
Week program on/off
New program step
Check program
A new program step does not replace a set
time for Day for example, but you can instead
select to change a program step.
To change a program step, select Change
program.
>Installer menu>Week program
Check program
Change program
Remove program
The program steps that should not apply
are removed in Remove program. One or all
program steps can be removed in the menu.
To return to the factory set basic program,
select Reset all.
>Installer menu>Week program
Check program
Change program
Remove program
GB
Sat Sun
New program step 7/16
Mode
Day
Tue 10:45
00:00
Tue 10:45
Mon Tue Wed Thu Fri Sat Sun
Tue 10:45
Mon Tue Wed Thu Fri Sat Sun
End
Tue 10:45
Change program
Mon Tue Wed Thu Fri Sat Sun
1. 08:00 Day
2. 18:00
Night
3. 10:00 Day
4. 16:00 Night Tue 10:45
00:00
Tue 10:45
Mon Tue Wed Thu Fri Sat Sun
Tue 10:45
Mon Tue Wed Thu Fri Sat Sun
End Tue 10:45
Remove program
Remove single
Remove all
Reset all
31