Disassembly Instructions - Mitsubishi Mr.SLIM MFZ-KA09NA Service Manual

10

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types (refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
MFZ-KA09NA MFZ-KA12NA MFZ-KA18NA
INDOOR UNIT
OPERATING PROCEDURE
1. Removing the panel
(1) Push both sides of the upper part of the front grille and
pull the front grille open, and then remove the front grille
from the panel. (See Photo 1.)
(2) Remove the screws of the panel. (See Photo 2.)
(3) Open the horizontal vane and push the left, right and
middle of the upper part of the panel, and pull the panel
toward you. (See Photo 2.)
(4) Lift up the panel and remove it from the box.
OBH568A
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
30
(2) The terminal with this connector has the
locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
NOTE: Turn OFF the power supply before disassembly.
PHOTOS
Photo 1
Push
Grille
Photo 2
Horizontal
vane
Push
Push
Screws of the panel
Push
Push