Mamiya RZ67 PRO II Instructions Manual page 25

Removing the Holder
Insert the Dark Slide into the Roll Film
Holder. For instant recognition, the Dark Slide
Slot is bordered by white reference lines. The
Film Holder can be removed after moving the
Holder Lock Lever as far as it will go toward
the Lock Release Lever
recommended that you remove the holder on a
table or similar support, or in your lap, to avoid
the possibility of dropping the holder or having
it fall off the camera.
If you attempt to remove the holder without
replacing the Dark Slide, the Holder Lock
Lever will automatically lock in place,
preventing accidental removal of the holder
and exposure of the film.
However, if you must remove the holder
without the Dark Slide in place, the automatic
lock can be overridden by pulling the Lock
Release Lever toward the Holder Lock Lever,
holding the lever there, and then moving the
Lock Lever.
Pulling out the Dark Slide of a
Detached Roll Film Holder
When detached from the camera body, the
Dark Slide cannot be pulled out. However, if
you wish to remove it, push in the pin "A" on
the holder with a pointed object.
"A". It is
23
Note: Non-Compatibility of Roll Film Holder
Inserts.
While all model RZ and RZ PRO II roll film
holders can be used with both the RZ and
RZ PRO II , this does not apply to the
interchangeability of the film holder inserts.
They can only be used with their respective
roll film holder housings.