Setting Oven Controls; Setting The Clock; Changing Between 12 Or 24 Hour Display - Kenmore 970-6982 Use & Care Instructions Manual

Setting Oven Controls

•

Setting the Clock

• Changing between 12 or 24 hour
display
Setting the Clock
The CLOCK pad is used to set the clock. The clock may be
set for 12 or 24 hour time of day operation. The clock has been
preset at the factory for the 12 hour operation. When the range is
first plugged in, or when the power supply to the range has been
interrupted, the timer in the display will flash with power failure "PF"
(See Fig. 1).
INSTRUCTIONS
To set the clock (example below for 1:30):
1. Press . "CLO" will appear in the display (Fig. 2).
2. Press
(Fig. 3). "CLO" will appear in the display. Press
will disappear and the clock will start (Fig. 4).
Changing between 12 or 24 hour time of day display:
1. Press and hold
pad down the current time of day will remain and "CLO" will
disappear from the display (Fig. 4). CONTINUE holding the pad
until "12 Hr"(Fig. 5) or "24 Hr" appears in the display.
2. Press to switch between the 12 and 24 hour time of day
display. The display will show either "12 Hr" (Fig. 5) or "24 Hr"
(Fig. 6).
3. Press to accept the desired change or press
reject the change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
Note: Changing between 12 or 24 hour time of day display will lockout the cooktop. See page 8 for complete
instructions for unlocking the cooktop.
pads to set the time of day to 1:30
for 6 seconds (Fig. 3). While holding the
PRESS
. "CLO"
for 6 seconds
to
or
19
Fig. 1
DISPLAY
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6