Reversing Door Swing; Removing Fhe Door - Kenmore 41791122310 Installation Instructions Manual

Reversing Door Swing
1. Be sure you have adequate swing area before
reversing door.
2. You wiii need a screw driver with a #2 square
and straight bit.
3. Protect flat work surface, such as top of dryer or
floor near dryer, with a soft cloth or towel.
4. Be sure dryer is unplugged from power source!
wA,,, ...................................
ELECTRICAL sH0CKHAZARD "
Failure to disconnect power source
before servicing could result in personal
injury or even death.
Tools needed:
Screwdrivers with
#2 square &
straight bit
Removing fhe door
1.
Protect flat
work
surface, such as top of dryer or
floor
near dryer, with a soft cloth or towel.
2. Open dryer door and remove the two hinge screws.
Remove lower screw first, then upper screw.
4. Gently place dryer door face down on flat, covered
work surface.
5. Locate the 5 indented head screws (no.
1-5)
in the small,
circular recesses (at 11, 1, 4, 6, and 8 o'clock positions)
of the inner door. Remove and save these 5 screws.
2
7
.
Supporting door with both hands, squarely lift door and
hinge upward approximately 3/8" (10 mm) so "T" post
on back of hinge can slide out through "T" slot on front
panel.
"T" SLOT IN
FRONT PANEL
"T" POST ON
DOOR HINGE
i i
i ,
5 4
Do not attempt to remove the 2 "tamper-resistant"
screws that hold the inner glass in place.
6. Locate the 2 pan head screws (no. 6-7) on the inner
door nearest the metal strike and center of hinge (9
and 3 o'clock positions). Remove and save these 2
screws.
7. Separate inner door assembly from outer door
assembly.
20