Kenmore 41791122310 Installation Instructions Manual page 16

Installation instructions
Water connection, continued
If your installation has room for the COLD water
supply to accept the "Y" connector directly, thread
the "Y" connector to the COLD water supply and
tighten it by hand until snug; then tighten it another
2/3 turn with pliers.
If you were able to install the "Y" connector directly to
the COLD water supply, please skip to step 8.
If there isnot enough room to install the "Y"
connector directly, thread a short extension hose
onto the COLD water supply and tighten it by hand
until snug; then tighten it another 2/3 turn with
pliers.
Short extension available from your local hardware
supplier. Extension hose must meet qualifications for use
in laundry installation.
7 Thread the "Y" connector to the short extension hose
and tighten it by hand until snug; then tighten it
another 2/3 turn with pliers.
8 Connect the COLD inlet hose for the washer to the
"Y" connector and tighten it by hand until snug; then
tighten it another 2/3 turn with pliers.
9 Connect the straight end of the long hose from the
kit to the other outlet on the "Y" connector and
snug if by hand. Connect the hose's 90 ° coupling
to the brass water inlet on the back of the dryer
and tighten it by hand until snug. Tighten each
connection of the dryer inlet hose another 2/3 turn
with pliers.
10 Turn on the water and check for leaks at all
connections.
DIRECT CONNECTION
OR WITH EXTENSION s
____ WATER INLET
ON DRYER
COLD WATER SUPPLY
HOSE TO WASHER
_Laundry hose extension not included with dryer.
\
16