Broan QP342BL Instructions Manual page 7

BR N
QP3 SERIES
[_ NON=DUCTED INSTALLATION ONLY:
From parts bag: Attach Non=Duct Diverter to Air Box
with 2 Screws and 2 Washers.
PLATE
PLENUM
SCREWS
J
SLOT
NON-DUCT
PLATE
[_ NON=DUCTED INSTALLATION ONLY:
Remove 2 Screws holding Non=Duct Plate to Non=Duct
Plenum and remove plate.
SCREWS
s
PLATE
[_ NON=DUCTED INSTALLATION ONLY:
Insert short end of Non=Duct Plate into Non-Duct
Plenum Slot. Attach with 2 Screws removed in Step 13.
Page 7
NON=DUCTED INSTALLATION ONLY:
Purchase a set of (2) non-ducted filters for 30" wide hoods
(Model BPPF30) & 36" wide hoods (Model BPPF36) or
a set of (3) non-ducted filters for 42" wide hoods (Model
BPPF42) from your local distributor or retailer. Attach the
non-ducted filters to the aluminum mesh filters following
instructions packed with the non-ducted filters.
FOR NON=DUCTEDINSTALLATIONS =Skip to "INSTALL
THE HOOD':
7" ROUND
KNOCKOUT
PLATE (also
remove 3W'x 10" L'_
vertical plate)
3W' X 10"
VERTICAL
KNOCKOUT
3W' X 10" PLATE
KNOCKOUT
PLATE
[_ DUCTED INSTALLATION ONLY:
Remove 3W' x 10 vertical, 3W' x 10" horizontal, or 7-inch
round knockout plate(s) as appropriate for your ducting
method.
7" ROUND
DUCT
PLATE
El
DUCTED INSTALLATION ONLY:
Attach 3W' × 10" Damper/Duct Connector (if using 3W'
x 10" duct) or 7" Round Duct Plate (if using 7-inch round
duct) over the knockout opening.
Notes:
To accomodate off-center ductwork, the 3W'x 10" damper/
duct connector can be installed up to W' on either side
of the hood center and the 7" round duct plate can be
installed up to W' on either side of the hood center.
Install the 3W'x 10" Damper/Duct Connector with the
Damper Flap Pivot nearest the Top/Back Edge of Hood.