Download Print this page

Kenmore 665.13273K118 Use & Care Manual page 91

Ultra wash dishwasher

Advertisement

Available languages

Available languages

DETERGENT AND RINSE AID
//
//
//
\
IMPORTANT:
Use only automatic dishwashing
detergent. Hand
dishwashing detergent will produce excessive suds and overflow
out of the dishwasher.
Recommended
Detergent
Amount
Add recommended
amount of detergent to each compartment
as shown and close the detergent
lid.
Powders and Gels
Water
Soil
Pre-Wash
Main Wash
Hardness
Level
Compartment
Compartment
Soft
Light
None
1/2
(0-4 grains
Normal
None
1/2
per U.S.
gallon)
Heavy
Full
1/2
Medium
Light
None
1/2
(5-9 grains
Normal
1/2
1/2
per U.S.
gallon)
Heavy
Full*
Full*
Hard
Light
1/2
Full*
(10-14 grains
Normal
Full*
Full*
per U.S.
gallon)
Heavy
Full*
Full*
*Full pre-wash compartment
contains 7 tsp (35 mL), and full
main wash cup contains 9 tsp (45 mL).
Premeasured Detergents
Many
detergents
now
come
in premeasured
forms
(gel
packs,
tablets, or powder packs). These forms are suitable for all
hardness and soil levels. Always place premeasured detergents
in the main compartment
and close the lid.
Using dishwasher detergent tablets and packs have been
proven better than powder, liquid or gel detergents to reduce
filming on your dishes. By using these tablets and packs, over
time this will start to reduce or eliminate white film. Also, by
using a rinse aid you can minimize repeat buildup of white film.
IMPORTANT:
Extremely hard water mineral deposits (15 grains
per U.S. gallon or more) can cause damage to your dishwasher
and make it difficult to achieve good results. A water softener is
recommended
to avoid damage
and achieve good results. You
may bring your water samples to Sears to check hardness level.
i USE RINSE AIDFOR
BETTER D RYING
Lock
Refill
Full
Add
IMPORTANT: Your dishwasher is designed to use a liquid rinse
aid. The use of rinse aids greatly improves drying by allowing
water to drain from the dishes after the final rinse. They also
keep water from forming droplets that can dry as spots or
streaks.
Filling the Dispenser
The dispenser holds 5 oz (150 mL) of rinse aid. Under most
conditions this will last 1 to 3 months.
1. Turn the knob to the REFILL position and remove.
2. Pour rinse aid into the opening until the indicator
points to
FULL. Do not overfill.
3.
Clean up any spilled rinse aid. Spilled rinse aid can create
excessive suds.
4.
Replace
the knob and turn to the LOCI<
position.
NOTE:
Indicator
reads
correct
fill level when door
is completely
opened.
Rinse Aid Setting
Your rinse aid dispenser
is adjustable.
For most water
conditions,
the factory
setting
will give good
results.
If you have hard water
and notice
calcium
buildup
on your
dishware,
you may want
to
try a higher
setting.
If you notice
foam
in your dishwasher,
use a
lower
setting.
Lock
Refill
To Adjust
the Setting
1.
Turn the knob
to the REFILL position
and remove.
2.
Turn the arrow
inside the dispenser
to the desired
setting.
3.
Replace
the knob and turn to the LOCI<
position.
11

Advertisement

loading