Maytag MVW18CSBGW0 Installation Instructions Manual page 16

ELECTRONIC CONTROLS SET-UP INSTRUCTIONS
Control Set-up Procedures
iMPORTANT: Read all instructions before operating.
The lower fabric setting key pads and the digital display are used
to set up the controls. The display can contain 4 numbers and/or
letters and a decimal point. These are used to indicate the set-up
codes and related code values available for use in programming
the washer.
How to use the key pads to program the controls
1. The LEFT UPPER (POWER WASH) key pad is used to adjust
the values associated with set-up codes. Pressing the key
pad will increment the value.
Rapid adjustment is possible by holding the key pad down.
2. The LEFT MIDDLE (NORMAL) key pad will advance you
through the set-up codes. Pressing the key pad will advance
you to the next available set-up code. Holding the key pad
down will automatically advance through the set-up codes at
a rate of one (1) per second.
3. The LEFT LOWER (DELICATES) key pad is used to select or
deselect options.
4. The RIGHT UPPER (TEMPERATURE) key pad is used to
decrease set-up code value.
Start Operating Set=Up
[] PD Models: insert access door key, turn, and lift to remove
access door.
[] PR Models: Once the debit card reader is installed (according
to the reader manufacturer's instructions), the set-up mode
can be entered by inserting a set-up card (supplied by the
reader manufacturer) into the card slot. If a manual set-up
card is not available, manual set-up mode can be entered by
removing connector AA1 on the circuit board.
IMPORTANT: The console must not be opened unless power is
first removed from the washer. To access connector AA1 :
-_ Unplug washer or disconnect power.
-_ Open console, disconnect plug on AA1, close console.
-_ Plug in washer or reconnect power.
The washer is now in the set-up mode.
Before proceeding, it is worth noting that, despite all of the
options available, an owner can simply choose to uncrate a new
commercial washer, hook it up, plug it in, and have a unit that
operates.
Set-up Codes
[] The LEFT MIDDLE (NORMAL) key pad will advance from code
to code.
[] The LEFT UPPER (POWER WASH) key pad will increase the
code value.
[] The LEFT LOWER (DELICATES) key pad will select or
deselect options.
[] The RIGHT UPPER (TEMPERATURE) key pad will decrease
the code value.
FOR PR MODELS: The set-up codes are the same as for the 'PD'
models except where noted.
The set-up code is indicated by the one or two left-hand
characters. The set-up code value is indicated by the two
or three right-hand characters.
6.04 NORMAL RegularCycleVendPrice- Increase or decrease
NORMAL between0 and200by pressingthe LEFTUPPER or RIGHT UPPER
keypad.Factorypresetfor 4 quarters= $1.00.
PR/PNMODELS ONLY: F actorypresetfor 0 quarters(FreeVend).
6.04 DELICATES R egularCycleVendPrice- Increase or decrease
DELIOATES between0 and200by pressingthe LEFTUPPER or RIGHT UPPER
keypad.Factorypresetfor 4 quarters= $1.00.
PR/PNMODELS ONLY: F actorypresetfor 0 quarters(FreeVend).
6.04 POWERWASH R egular C ycleVendPrice- Increase or decrease
P0WERWASH between0 and200by pressingthe LEFTUPPER or RIGHT UPPER
keypad.Factorypresetfor 4 quarters= $1.00.
PR/PNMODELS ONLY: F actorypresetfor 0 quarters(FreeVend).
-_ Pressthe LEFTMIDDLEkeypadonceto advanceto next code.
7.00 ADDITIONAL WASHTIME
7.00 This isthe numberof minutesthatcan be addedto aWashCycle.
Choosefrom 00-05minutesby pressing the LEFTUPPERkeypad.
-e Pressthe LEFTMIDDLEkeypadonceto advanceto next code.
8.00 ADDITIONALRINSETiME
8.00 This isthe numberof minutesthatcan be addedto a RINSECycle.
Choosefrom 00-05minutesby pressing the LEFTUPPERkeypad.
NOTE: A dditionalrinsetime onlyavailableindefaultedbathrinses,
not in sprayrinseoption.
--> Pressthe LEFTMIDDLEkeypadonceto advanceto next code.
9.00 CYCLECOUNTEROPTION
This option is eitherSELECTED 'ON' or NOTSELECTED 'OFF'.
9.00 NotSelected'OFF'.
9.0C Selected'ON' and not ableto be deselected.
Pressthe LEFTLOWER keypad3 consecutivetimesto select
'ON'.Onceselected'ON' it cannotbe deselected.
-_ Pressthe LEFTMIDDLEkeypadonceto advanceto next code.
1.00 MONEYCOUNTEROPTION
This option is eitherSELECTED 'ON' or NOTSELECTED 'OFF'.
1.00 NotSelected'OFF'.
1.0C Selected'ON'.
Pressthe LEFTLOWER keypad3 consecutivetimesto select
'ON' and3 consecutivetimesto remove(NotSelected'OFF'.)
Counterresetsby goingfrom 'OFF'to 'ON'.
1.CO Selected'ON' and not ableto be deselected.
Toselect'ON' andnot able to bedeselected,first select'ON',then
withintwo secondspressthe LEFTLOWERkeypadtwice,the
LEFTUPPERkeypad once,andexitthe set-upmode.
-_ Pressthe LEFTMIDDLEkeypadonceto advanceto next code.
2.00 SPECIALPRICINGOPTION
This option is eitherSELECTED 'ON' or NOTSELECTED 'OFF'.
2.00 NotSelected'OFF'.
2.SP Selected'ON'. Pressthe LEFTLOWERkeypadoncefor this
selection.
If SPECIALPRICINGOPTIONis selected, there is access to codes '3.'
through '9.'.
NOTE: A n externalbatteryneedsto be addedto keepthe clockrunningduring
periodsof poweroutages.
-_ Pressthe LEFTMIDDLEkeypadonceto advanceto next code.
16