Gigabyte GA-Z170X-Gaming G1 Owner's Manual page 35

_
12) M2B_32G/M2C_32G (M.2 Socket 3 Connectors)
The M.2 connectors support M.2 SATA SSDs and M.2 PCIe SSDs and support RAID configuration through
the Intel
an M.2 SATA SSD or a SATA hard drive. To create a RAID array with an M.2 PCIe SSD, you must set
up the configuration in UEFI BIOS mode. Refer to Chapter 3, "Configuring a RAID Set," for instructions
_
S B_
on configuring a RAID array
S B_
_ S
S_
_ S
_ U
_
S_
Follow the steps below to correctly install an M.2 SSD in the M.2 connector.
F_USB3 F
_ U
_
F_USB3 F
_ _B
Step 1:
Use a screw driver to unfasten the screw and nut
from the motherboard. Locate the proper mount-
_ _B
ing hole for the M.2 SSD to be installed and then
screw the nut first.
Step 3:
Press the M.2 SSD down and then secure it with
the screw.
B
Chipset. Please note that an M.2 PCIe SSD cannot be used to create a RAID set either with
®
B
B
B
_
B
B
_
B
B
On the motherboard there are three length adjustment holes for the M.2 SSD. Select the proper hole
for the M.2 SSD to be installed and refasten the screw and nut.
B S_
B
B S_
B
80C 60C 42C
80B 60B 42B
F
F
_ 0
_ 0
_ F
Step 2:
Slide the M.2 SSD into the connector at an angle.
_ F
_ 0 F
_ 0 F
Step 4:
The installation is completed, as shown in the
picture above.
- 35 -
S
S
M2C_32G
S
S
M2B_32G
Hardware Installation