1-11 Installing the GC-USB3.1 BAY
Step 1:
Install the GC-USB3.1 BAY in the chassis and fasten it with screws.
Then connect one end of the cable to the SATA Express connector
on the motherboard.
Please connect the cable to the SATA Express connector
consisting of the SATA3 0, 1 or SATA3 2, 3 connectors.
Step 2:
Connect the other end of the cable to the SATA Express connector
on the GC-USB3.1 BAY.
Step 3:
Connect the SATA power cables from the power supply to the SATA
power connectors on the GC-USB3.1 BAY. You must connect the two
connectors with separate power cables.
The Power Delivery function can be enabled only when the
system is powered on.
- 27 -
Hardware Installation