GE PSB42YSHASS Owner's Manual And Installation Instructions page 36

Installation Instructions
1-81 SECURE REFRIGERATOR
TO CABINETS
Whenever possible, perform this step for anti-tip
security or when anti-tip brackets cannot be used.
The refrigerator must be secured to prevent
tipping.
• Raise the grille panel to access case trim.
• Drill a hole in the trim and drive a screw through
the trim into the adjacent cabinet.
• Follow the same procedure on the opposite side.
\r\
;; Drive Screws , ,_
ThroughCaseTrimInt0
Adjacent Cabinets
rg-]ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 130 °, you may change the door swing to
a 90 ° opening.
SKIP THIS STEP IF DOOR OPENING IS
SATISFACTORY FOR YOUR INSTALLATION
SITUATION.
• Open the door to view the bottom hinge.
Note the door stop pin location. The pin is factory
installed in the 130 ° position.
• Partially close the door. From above, use
a flat-head screwdriver to unscrew the door
stop pin and reinstall into the 90 ° position.
///
Interior
00r
Hinge
N-0"IINSTALL GRILLE PANEL
• Raise the grille panel to the stop position.
Grille
AA
• Remove 4 screws on bottom trim; retain
all screws.
• Remove bottom trim.
• NOTE: Stainless steel and acrylic panels are
covered with a protective film. Remove the film
before installing the panel.
• Slide panel over the metal backer panel and
under the trim.
& & & &
• If necessary, tap with a wood block until panel
slips under the top trim piece.
• Reassemble bottom trim. Tighten screws.
36