Table of Contents
Advertisement
Available languages
Available languages
Installation
Instructions
CUSTOMIZATION
BASICS:
Stainless
Steel Wrapped
Models
42" wide modeI--PSB42YS
48" wide modeI--PSB48YS
Stainless Steel wrapped
refrigerators
have wrapped
doors and grille panels, and beveled edges. These
models are shipped ready for installation.
Trimmed
Models
42" wide models--PSB42YG
48" wide models--PSB48YG
Trimmed
refrigerators
are designed to be
customized
with decorative
panels. Field installed
custom door and grille panels are required. Panels
can be framed or full-width
and can use either the
pre-installed
handles or custom handles provided
by your cabinet manufacturer.
Framed Custom
Panels
You may install custom panels from your cobinet
manufacturer.
The decorative
panel slides into
the factory
installed trim. A 1/4" finished panel
can be used.
Framed P anel
You may install a 5/4" panel attached
to a 1/4"
backer panel. If the pre-installed
door handles are
used, the backer panel will be exposed by the handle
and therefore
must be finished (page 24). Custom
handles can also be used.
DoorHandles
Full-Width
Overlay
Custom Panels
Full-width
overlay custom panels are designed
to slide into the factory-installed
trim, no kits
required.
In this design, you can achieve a nearly
trimless appearance.
A 0.10" spacer panel must be installed between
the finished 1/4" backer panel and 3/4"
appearance
panel. If the pre-installed
door
handles are used, the backer panel will be
exposed near the handle and therefore
must be finished (page 24).
3/4" Overlay Panel
.10" Thick Spacer Panel
1/4" Thick Backer Panel
[]
Door Handles
The pre-installed
handles can accommodate
both framed or overlay panels. Custom handles of
your choice, supplied by your cabinet maker, can
be installed only on 3/4" overlay panels. When
installing
custom handles
measure to ensure
the mounting
for the handles selected will clear
the dispenser when installed on the freezer door.
Handles need to mount on the upper and lower
wood panels of the freezer door and not
on the dispenser. If a custom handle is used, only
the 3/4" overlay panel must be exposed, and the
custom trim pieces should be installed (page 38).
CustomTrim Pieces
3/4" OverlayPanel
.10" ThickSpacerPanel
1/4" Thick BackerPanel
CustomDoor Handles
2O
Advertisement
Table of Contents
