Replacing The Light Bulbs - GE PSB42YSHASS Owner's Manual And Installation Instructions

Replacing the light bulbs.
Setting the controls to
OFF
does not remove power to the fight circuit.
Refrigerator Compartment--Upper Light
(appearance may vary)
_ Light bulbs may be hot.
Burned out bulbs may break when being
replaced.
0 Raise the grille panel, set the master power
switch to the O(off)position and allow
lamps to cool.
0 To remove the light shield, press on the
sides of the shield and pull down.
Replace the bulbs with appliance bulbs of
the same or lower wattage. Replace the
shield by engaging the bottom tab into the
slot and applying light forward pressure
until the shield snaps in place.
Set the master power switch to the/(on)
position and close the grille panel.
Refrigerator Compartment--Lower Light
This light is located above the top drawer,
Raise the grille panel, set the master power
switch to the 0 (off) position
and allow lamps to cool.
Remove items from the shelf above
the light shield. Remove the shelf.
Use both hands to grasp each end
of the light shield. Press in on the bottom of
the shield with your thumbs while rotating
the cover up and out.
Replace the bulb with an appliance bulb of
the same or lower wattage. Replace the
shield by engaging the bottom tab into the
slot and applying light forward pressure
until the shield snaps in place.
Set the master power switch to the/(on)
position and close the grille panel.
I
Freezer Compartment
0
Raise the grille panel, set the master power
switch to the 0 (off)position and allow
lamps to cool.
Remove the items from the shelf just below
the light shield. Remove the shelf.
To remove the light shield, press down on
the top of the shield and pull the tabs out of
the slots. Tilt the shield forward and out.
O
Replace the bulb with an appliance
bulb of the same or lower wattage,
and reinstall the light shield. Replace
the shield by engaging the bottom tab into
the slot and applying light forward pressure
until the shield snaps in place.
Set the master power switch to the I(on)
position and close the grille panel.
Dispenser
Raise the grille panel, set the master power
switch to the 0 (off) position
and allow lamps to cool.
The bulb is located in the dispenser under
the control panel. Remove
the two screws from the light shield.
Slide the light shield toward the dispenser
to disengage the tabs, then remove the
light shield. Remove the light bulb by
turning it counterclockwise.
Replace the bulb with a bulb
of the same size and wattage. Replace
the light shield by sliding the tabs into
the slots in the front of the dispenser.
Replace the two screws.
Set the master power switch to the/{on)
position and close the grille panel.
14