Wiring Diagram - Whirlpool UXT5230BDB0 Installation Instructions And Use & Care Manual

To Replace the Filter:
1. To reinstall the filter, place the back edge of the filter into the
channel at the rear of the range hood.
2. Pull the filter latch toward the front of the range hood and
push the front of the filter up into place.
3. Release the filter latch. It will spring back into place to secure
the filter.
4. Replace the screw in the filter retainer.
Replacing a Halogen Lamp
Turn off the range hood and allow the halogen lamp to cool. To
avoid damage or decreasing the life of the new lamp, do not
touch the lamp with bare fingers. Replace the lamp, using tissue
or wearing cotton gloves to handle the lamp.
If new lights do not operate, make sure the lamps are inserted
correctly before calling service.
1=
2.
Disconnect power.
Use a flat-blade screwdriver and gently pry the light cover
loose.
3. Remove the lamp and replace it with a 120-volt, 40-watt
maximum, halogen lamp made for a G-9 base.
4. Replace the light cover.
5. Reconnect power.
WIRING DIAGRAM
N
8
Ground
Screw
Gnd
SwitchOperation
L-1 Lamps 120V 1.5Ohms
L-2 Speed1 120V 1.5Ohms
L-3 Speed2 120V 2.0 Ohms
L-4 Speed3 120V 2.5 Ohms
W
Y
w
SE119A
i
BK (Line)
Y (Lamp)
GY (Speed3)
Mechanicalpush buttons I
(_ butt_ (_)3sp_sc)
I' " TII
S15
R (Speed2)
BR (Speed1)
MotorCharacteristics
Power S upply 120VAC
Frequency 60 Hz
Amperage 0.9__.10% A
Wattage Rating 110 Watts
MotorResistance
Red- Brown 27.5__.10% O hms
Red-Black 55.7+10%Ohms
Red- Gray 86.8__.10% O hms
Red-White 117.7__.10% O hms
11