Direction For Use; Troubleshooting Guide - Hyundai HUM 500 Instruction Manual

OPERATION INSTRUCTION

DIRECTION fOR USE

• This humidifier should be placed under ambient temperature for half an hour before it is put
into use for the first time.
• The desired operating environment for this humidifier is: temperature: 5-40 °C and relative
humidity 80%RH max.
• Use clean water with temperature below 40 °C, purified water is recommended.
• It is normal if there a little bit water remain in the water tank after the machine switches off
automatically because of lack of water.
CONTROL
• When you use the humidifier for the first time, please take it out from the package.
• Spin the cover of water tank to open it, pour water into it then screw down.
• Connect the appliance to the electricity supply. Turn on by power switch P1, power light turns
on. and open the upper cover to put the water tank steadily on its stand, Set the steam of mist
by turnign control knob P9 to select slight or heavy mist volume.
• Press rotary moisture outlet switch (P6) for start rotation moisture outlet (P7).
• When you clean the machine or pour out the water, you should put a container on the outfall,
spin the cover to open it and pour the water into the container. When the machine is clean,
please screw down the cover again.
TROUBLE SHOOTING GUIDE
In case your humidifier does not work properly, please examine your machine before asking for
maintenance service.
Fault Sympton
Power light on, air blown but
no mist.
Peculiar smell of mist.
Power light on but no blow or
no mist.
Small mist output.
Abnormal noises.
In case the humidifier is still unable to work normally after the above treatment, please contact
the supplier or local maintenance center. We will provide you with wholehearted services.
Analysis of causes
No water in the tank.
Cover of water level protecti-
on switch not closed properly.
New machine.
Dirty Water or water stored in
the tank for a long time.
Water level too high in the
tank.
The transducer is dirty.
Dirty water or water stored in
the tank for a long time.
Resonance caused by insuff-
icient water in the water basin.
Resonate with the surface
where the unit is placed.
ENG - 23
Failure Recovery Method
Fill the water into the tank.
Reinstall the cover.
Keep the water tank unco-
vered in a cool place for 12
hours.
Clean the water tank and refill
the tank.
Keep the water in an ordinary
level.
Clean the transducer.
Clean the water tank and refill
the water.
Add water into the basin.
Place the unit in the stady
surface or ground.
ENG